Lucent Technologies Transtalk 9000 manual Installing a Single Carrier on a Wall

Installing a Single Carrier on a Wall

■Install high on wall, leaving 6–12 inches (15.2–30.5 cm) between antennas and ceiling

■Never install or remove a radio module from a carrier that is plugged into a wall outlet (hot insertion)

■See “Key Components” earlier in this chapter for additional picture detail

1Perform the tests described in "Wireless Test Mode" earlier in this chapter to determine the

optimal placement of the radio module. To perform the tests, all you need is an electrical outlet for the radio module and a charged battery pack in the handset.

2Check to make sure the carrier’s power cord is unplugged from the wall outlet before continuing.

3Place the carrier against the wall. Choose a loca- tion backed by a wooden stud (if unavailable, use

toggle bolts instead of the supplied wood screws). Hold the carrier straight; use a level if needed. Using a nail or pencil, mark screw locations through the four wall-mount holes.

Start the screws, leaving the screw heads protruding approximately 1/2" (12 mm) from the wall. Place the car- rier assembly over the screws, then slide it downward to lock it into place. Tighten the screws.

4Remove the plastic cap covering each radio module’s card edge before inserting the radio

modules into the carrier.

4 TRANSTALK

CAUTION
	IN
	OUT
OUTOF	SYNC

1 2 3 4 5 6

Installing the MDW 9030P Pocketphone 2-21