Lucent Technologies Transtalk 9000 manual Out, 20Installing the MDW 9030P Pocketphone

9

Insert the carrier’s AC adapter cord into the left side of the carrier.

1 2 3 4 5

10Place the carrier on its feet towards the back of the shelf or desk, making sure it is in a stable

position. Be sure the telephone line cords come out the rear exit slots in the back of the unit. Arrange the power cord and telephone line cords beneath the shelf or desk so no one can step on them or trip over them.

11Insert the carrier’s power cord into the AC adapter, then plug the power cord into a

properly grounded 3-prong wall outlet that is not controlled by an on/off switch.

If appropriate, you can wall-mount the AC adapter using its attached wall-mounting bracket.

! CAUTION:

Never connect or disconnect telephone line cords, or insert or remove radio modules, while the carrier is plugged into the wall outlet.

12Verify that the carrier’s Out of Sync LED is not lit. If the LED is lit, power down and then

repower the carrier. If the LED is still lit, follow the suggestions in the "Installation Problems" section of Chapter 5, "Troubleshooting." If the LED is still lit, call for help as described on the inside front cover of this book.

Go to “Installation Self-Test.”

		OUT
		YNC
OUT	OF	S
4

2-20Installing the MDW 9030P Pocketphone