3
Press up and hold the snap lock on the bottom rear of the radio module.
4Slowly swing the radio module's card edge out of the card edge connector on the back of the
carrier, releasing the snap lock when clear. Unhook the radio module from the radio module mounting rod by gently lifting upward.
5If you removed a radio module from Slot 6 of a carrier that has another carrier to the right of it,
you must insert another radio module into this slot. Slot 6 of any carrier must always be filled if there is another carrier to the right of it. Failure to do so will cause the carriers to be unsynchronized.
6Repower the carrier. If you have multiple carriers, repower them in order from left to right,
as shown below:
4 | 4 | 4 |
1 | 2 | 3 | 4 | 5 | 6 |
1 | 2 | 3 | 4 | 5 | 6 |
1 | 2 | 3 | 4 | 5 | 6 |
Control | Expansion | Expansion |
Carrier | Carrier #1 | Carrier #2 |
1 | 2 | 3 |