Lucent Technologies Transtalk 9000 manual Battery Charger Problems, Handset LED on

Page 88

Battery Charger Problems

Symptom

Possible Causes

Possible Solutions

 

 

 

No LEDs on battery

Battery charger is plugged

Plug the battery charger into

charger light.

into an electrical outlet

an outlet not controlled by a

 

controlled by a switch and

switch.

 

the switch is turned off.

 

 

 

 

HANDSET LED on

Handset is not seated

Reseat the handset in the

battery charger does not

properly in battery

battery charger's handset

light when handset is

charger's handset cradle.

cradle, as described in Chap-

placed in battery charger.

 

ter 3.

 

 

 

 

The contacts in the hand-

1. Verify that there are no

 

set cradle or on the battery

obstructions on the handset

 

pack are dirty.

or battery charger contacts.

 

 

2. Unplug the charger and

 

 

clean the contacts with a soft

 

 

eraser.

 

 

3. Clean the handset contacts

 

 

with a soft eraser.

 

 

 

 

The battery pack is defec-

If you have a fully charged

 

tive.

spare battery pack, use it to

 

 

replace the battery pack in the

 

 

handset.

 

 

1. Place the questionable battery

 

 

pack in the battery charger’s

 

 

Spare battery compartment.

 

 

2. Wait one minute. If the

 

 

SPARE LED flashes red, order

 

 

a new battery pack.

 

 

 

Troubleshooting 5-13

Image 88
Contents TransTalk Digital Wireless System Trademarks Contents Using the MDW 9030P Pocketphone Maintaining the MDW 9030P Pocketphone IiiPage What Is a Wireless Phone? About TransTalk 9000 ProductsTransTalk 9000 System IntroductionSingle Carrier Installation 2IntroductionAbout the MDW 9030P Pocketphone Where Can You Use Your Pocketphone?Privacy Information Parts List 4IntroductionAdditional Parts Rubber FeetSpare Battery and Headset 6IntroductionImportant Safety Instructions Installing the MDW 9030P Pocketphone2Installing the MDW 9030P Pocketphone Guidelines for Safe and Efficient OperationExposure to Radio Frequency Energy Cardiac PacemakersBasic Safety Precautions for Installation and Use Additional Safety Instructions for Installation Personnel 4Installing the MDW 9030P PocketphoneAC Outlet Check 6Installing the MDW 9030P Pocketphone Radio Modules and CarriersKey Components Pass8Installing the MDW 9030P Pocketphone Positioning a Radio Module or Carriers General Positioning Rules10Installing the MDW 9030P Pocketphone Additional Rules for Installing a Single Radio Module OnlyWireless Test Mode 12Installing the MDW 9030P Pocketphone Display Number Signal Strength IsInstalling a Single Radio Module 14Installing the MDW 9030P Pocketphone Setting the Power Level 16Installing the MDW 9030P Pocketphone Desired Range ApproximateSetting the Control/Expansion DIP Switch Installing a Single Carrier on a Shelf or Desk 18Installing the MDW 9030P PocketphoneMusic 20Installing the MDW 9030P Pocketphone OUTInstalling a Single Carrier on a Wall 22Installing the MDW 9030P Pocketphone Book Installing Multiple Carriers 24Installing the MDW 9030P PocketphoneCarrier, doing so causes all handsets to work 26Installing the MDW 9030P Pocketphone Music 28Installing the MDW 9030P Pocketphone If the carriers are plugged into ThenInstallation Self-Test 30Installing the MDW 9030P Pocketphone Inserting and Removing Handset’s Battery PackHandset Changing the Communications System Setting MAPM232Installing the MDW 9030P Pocketphone Filling Out the Handset LabelPositioning the Battery Charger Battery ChargerInstalling the Battery Charger 34Installing the MDW 9030P Pocketphone Inserting a Battery Pack into the Spare Battery Compartment Removing a Battery Pack From the Spare Battery Compartment36Installing the MDW 9030P Pocketphone Inserting the Handset into Battery Chargers Handset CradleRemoving the Handset from the Handset Cradle Using the MDW 9030P Pocketphone Using the MDW 9030P Pocketphone2Using the MDW 9030P Pocketphone Handset ControlsColumn and Select Buttons 4Using the MDW 9030P Pocketphone Handset DisplayLine Status Indicators Display MessagesLow Battery Indicator Range Indicators6Using the MDW 9030P Pocketphone Volume Control Carrying Your PocketphoneChanging the Handset Settings Changing the Communications System Button Mapping Setting8Using the MDW 9030P Pocketphone AntennaEnabling or Disabling the Vibrator Enabling or Disabling Line Preselection10Using the MDW 9030P Pocketphone Enabling or Disabling the Alerter 12Using the MDW 9030P Pocketphone Using Local Test ModeTest Modes Using Wireless Test Mode 14Using the MDW 9030P Pocketphone Performance/Range Test in Wireless Test ModeMaking a Call Waking Up the PhoneAnswering a Call Manually Selecting a Line or Programmed Button 16Using the MDW 9030P PocketphonePreselecting a Line Using the Headset On/Off Button Using a HeadsetAnswering Calls with a Headset 18Using the MDW 9030P Pocketphone Placing Calls with a HeadsetBattery Charger Battery Charger Features20Using the MDW 9030P Pocketphone Extending Battery Life 22Using the MDW 9030P Pocketphone Maintaining the MDW 9030P Pocketphone Maintaining the MDW 9030P Pocketphone2Maintaining the MDW 9030P Pocketphone Swapping Extensions ReplacingtheAntenna 4Maintaining the MDW 9030P PocketphoneOrdering Replacement & Optional Parts InstallationProblems ProceduresTroubleshooting 2Troubleshooting Power and PassPower and Pass LEDs on Handset Problems 4TroubleshootingHandset Problems Battery Problems 6TroubleshootingVoice Quality Problems For a multiple-carrier installation8Troubleshooting PARTNER, Part Range Problems 10TroubleshootingRange Problems 12Troubleshooting Placed on HoldBattery Charger Problems Handset LED on14Troubleshooting Battery Charger Problems 16Troubleshooting MDW9030PPocketphoneCompatibility MDW 9030P Pocketphone Compatibility2MDW 9030P Pocketphone Compatibility Communications System Compatibility Partner Systems Button Mapping for Partner SystemsSetting the Line-Ringing Options 4MDW 9030P Pocketphone CompatibilityMerlin Systems 6MDW 9030P Pocketphone Compatibility Recall DropButton Mapping for Merlin 410 and Merlin 820 Systems DropSetting the Line Ringing Options 8MDW 9030P Pocketphone CompatibilitySystem 25, System 75, System Definity Systems Definity G1 R1V410MDW 9030P Pocketphone Compatibility DropScroll Display 12MDW 9030P Pocketphone Compatibility Lucent Technologies Limited Warranty Limitation of Liability Warranty and Repair Information A-1In-Warranty Repairs 2Warranty and Repair InformationRepair Information Limitation of LiabilityPost-WarrantyRepairs Warranty and Repair Information A-3FCC Part 15 Rules IC RSS-210 ComplianceHearing Aid Compatibility Regulatory Information B-1Specifications Specifications C-12Specifications PowerIndex Index IN-1IN-2 Index Index IN-3 No LinkIN-4 Index Battery Charger Wall-Mounting Template Lucent Technologies Comcode Issue March