Lucent Technologies Transtalk 9000 manual 20Using the MDW 9030P Pocketphone

The color of the battery charger's LEDs indicates the state of the corresponding battery pack, as shown in the following table:

					If it is the REFRESH
	If it is the SPARE LED,				LED, the Refresh
	the battery pack in the		If it is the HANDSET		button was pressed,
Battery charger	Spare battery		LED, the battery pack		and the Handset
LED shows...	compartment...		in the Handset...		battery pack...
Steady orange	Is charging		Is charging		N/A
Steady green	Is fully charged		Is fully charged		N/A
Flashing red	Has one of the		Has one of the		N/A
* See note.	following problems:		following problems:
	•	Is not seated	•	Is not seated
		properly in the		properly in the
		charger		charger
	•	Has dirty contacts	•	Has dirty contacts
	•	Is defective	•	Is defective
Steady red	Is in the Discharge		Is in the Discharge		Is in the Discharge
	portion of the Refresh		portion of the Refresh		portion of the Refresh
	cycle.		cycle.		cycle.

*Note: If either the SPARE LED or the HANDSET LED is flashing red, both battery packs must be removed from the charger to clear the flashing-red condition. Address the possible problems for one battery pack at a time to determine whether one is bad.

NOTE:

Before you use the MDW 9030P Pocketphone handset for the first time, the battery pack must be charged.

3-20Using the MDW 9030P Pocketphone