Motorola i860 manual Accessory Swap Test, Lockup Test, Lockup test time is approximately 6 minutes

Page 41

BASIC LEVEL CHECKS AND SELF TESTS: Mechanical and Electrical Checks

5.Power on the unit, and verify that the test SIM card works with the unit.

If the unit works, the customer’s SIM card is defective and should be replaced, or the problem is due to operator error, system, or carrier. If the unit does not work, the unit is defective and should be sent to the iDEN Radio Support Center.

NOTE: If a defective SIM card is replaced with a new card or test card, all personal information (voice notes, datebook entries, etc.) that was stored on the original card will be lost.

6.Install the customer’s SIM card in a test (reference) unit.

If the test unit works, the customer’s unit is defective and should be sent to the iDEN Radio Support Center

5.5.2Accessory Swap Test

Use this test to determine if the unit’s accessories are defective.

NOTE: When adding or removing accessories, the main screen displays “Device Attached” or “Device Detached” and the external screen displays a similar message.

The accessory swap test time is approximately 5 minutes:

1.Remove the accessory and check the contact areas for foreign material, damage, or other defects.

2.Replace the problem accessory with the reference accessory.

3.Verify the reference accessory works with the unit.

If the reference accessory works, the customer’s accessory is defective and should be replaced.

4.Verify the customer’s accessory works with a reference unit.

If the accessory works, the customer’s unit is defective and should be sent to the iDEN Radio Support Center.

5.5.3Lockup Test

Use this test to determine if the unit locks up when keys are pressed or when it is powered down.

The lockup test time is approximately 6 minutes:

1.Power up the unit.

2.Press eto clear display inputs.

3.Press each of the alphanumeric keys to see if the unit responds. If the unit does not respond to a pressed key, remove the battery to cycle power on.

If the problem persists after several tries, replace the unit.

5-4

68P80400P73-A

Image 41
Contents Page I860 Manual Revisions Safety and General Information Medical Devices Electro Magnetic Interference CompatibilityCleaning and Drying Considerations Accessory Safety InformationSafety and General Information Model Numbering System Model InformationGeneral Receiver Transmitter Model SpecificationsContents Chapter Chapter Field Level Test Modes Procedures Appendix a Ordering Replacement Parts How This Manual Is Organized PrefaceWho Should Use This Manual Related Publications Conventions Used in This ManualDEN Digital Modulation Technology OverviewSpectrum of i DEN Quad 16QAM RF Transmission Bursts DEN Voice Compression TechnologyCalling Area Coverage Removing and Inserting a SIM Card Global Positioning System GPS SectionSIM Cards To insert a SIM card Figure To remove a SIM card FigureComponent Views COMPONENTS, ICONS, and IndicatorsMain Menu Icons Display IconsStatus Icons Abc d efg d Opqr sCall Icons DEFOutbox Icons Contacts Type IconsThis page intentionally left blank DISPLAYS, MESSAGES, and Alerts Power-Up SequenceSelf-Test Errors Power-Down SequenceSelf-Test Reset Errors MessagesMessage Cause Action Service MessagesService Messages Alert Tones Tone Low High Freq Cadence When Tone OccursAlert Tones Alert Tones Vibrator Settings Using the Optional Vibrate FunctionMode Cadence To set unit to vibrate for all callsFrom the main menu, select Settings 2-Way Radio Alert Type This page intentionally left blank Reference Accessories Preparing for Basic Level TestingTest Equipment Reference UnitThis page intentionally left blank Basic Level Checks and Self Tests Reset ConditionCustomer Care Test ConditionsPreventive Maintenance Basic-Level Test ChecklistBasic-Level Test Checklist To clean the unit approximately 3 minutesSIM Card Swap Test Mechanical and Electrical ChecksShock and pressure test time is approximately 3 minutes SIM card swap test time is approximately 5 minutesAccessory swap test time is approximately 5 minutes Accessory Swap TestLockup Test Lockup test time is approximately 6 minutesTesting the GPS Receiver Battery Connections TestBattery connections test time is approximately 5 minutes To test this functionVoltage recognition test time is approximately 4 minutes Voltage Recognition TestCamera Test Self-Test Procedures TroubleshootingPasscode Test Passcode test time is approximately 5 minutesPhone Calls Features Programming Menu Settings CheckSettings check test time is approximately 10 minutes Way Radio Options Personalize Volume FeaturesFrom the main menu, select Settings Security SIM PIN Security FeaturesFrom the main menu, select Settings Advanced Headset/Spker Advanced FeaturesCall performance test time is approximately 7 minutes Call Performance TestThis page intentionally left blank Entering Debug Mode Basic Level Test Modes and ProceduresTo enter debug mode Test ModesName Description Display ScreensDisplay Screens To enter test mode Entering Test ModeTo perform the audio loopback test test time approx min Test Mode Test ProceduresAudio Loopback Test Engineering Debug Check ESN and Imei Matching TestTo perform the matching test test time approx min To monitor the data in the unitSoftware choice 68P80400P73-A Programming the i 860 Unit Technician Test ProceduresData Cable Programming Setup Connecting the Unit to the RSS WorkstationTo access the codeplug Help topic in Windows Codeplug Repair ProcedureCodeplug Troubleshooting Preparing Equipment for Testing Preparing for Field Level TestingConnecting an i DEN Unit to the R-2660 Using RSSCoaxial Cable In/Out Type To connect the unit to the R-2660Operating the R-2660 To enter Initial Registration modeRF Zone Fields and Values Field ValueDisassembling and Reassembling the Unit Install Battery CoverSIM Card RemoveRequired Tools T-4 Torx bit AntennaBack Housing Required Tools Black stick Coin CellMain Board, Microphone Seal, and Keypad Remove Flip Assembly Flip AssemblyPage Install Page Exploded View and Parts List Description Part Number Reference Component Parts ListComponent List Exploded View This page intentionally left blank Field Level Test Modes and Procedures Required Test Equipment Field-Level Test ChecklistDone Technical Tests Pass Fail Field-Level Test ChecklistRegistration/Call Test See the Strong Signal Environment sectionSQE Test SQE Reference ChartSee Entering Test Mode Press Menu, Edit TX Power TestFail BER TestPower-Up Test Keypad Test Use this test to check the audio portion of the unit Audio TestNo reset Reset Reset TestTo perform the reset log test Reset Log TestModel Assembly MA Test Mode Test Model Assembly MA Test Mode Test Use this test on a unit to check functionality of the GPS GPS ReceiverCamera Test Customer Service Ordering Replacement Parts and KitsReplacement Parts Domestic OrdersDescription Kit Number Replacement KitsTable A-2. i 860 Replacement Kits Vehicle Power Adapters Description Part Number Recommended Test Equipment and ToolsTable A-3. Recommended Test Equipment and Tools Table A-4. Recommended Programming Equipment Recommended Programming EquipmentTable A-5. Recommended Software Name Part Number DescriptionThis page intentionally left blank Bcch IndexQAM RSS Vselp @6880400P73@