Motorola i860 manual Entering Test Mode, To enter test mode

	BASIC LEVEL TEST MODES AND PROCEDURES: Test Modes
Table 6-1. Display Screens (Continued)
Name	Description
IMEI/SIM ID	Displays the electronic serial number and SIM ID serial number.
	The IMEI is the global name assigned to the mobile station at manufacturing time and should
	correspond to the serial-number tag of the unit.
	The SIM ID is the SIM electronic serial number and should correspond with the number
	stamped on the SIM card.
	Pressing OK allows the IMEI/SIM ID to be traced.
Registr Log	Displays the Dispatch Log, Interconnect Log, Packet Data Log, Mobile IP Log, and Phone
	Rst Log. Registration Log information is updated when the user deselects and selects the
	Registr Log choice.
Err/Chan Codes	Displays the physical channel that the unit is connected to or the radio link procedure that is
	currently active. Also, displays error codes of errors encountered during normal operation if
	Err/Chan codes is On. At power up, the Err/Chan Codes is Off.
Current Freq	Displays current frequency and band. Pressing OK allows the current frequency and band to
	be traced.
Dispatch IDs	Displays the Dispatch Group ID affiliated with the unit in the current dispatch-location area.
	Also, displays the Dispatch Individual ID affiliated with the unit in the current dispatch
	location. Pressing OK allows the dispatch IDs to be displayed periodically.
Band Info	Displays primary and secondary bands.
Bandmap	Displays the currently selected regional bandmap. Pressing OK allows the bandmap to be
	displayed periodically.
Hardware	Displays the AFC Offset and Channel Number.
	Pressing OK allows the hardware parameters to be traced.
Fatal Err/#	Displays the Fatal Error log. This log contains a count of any fatal errors logged during the
	unit's automatic self test. Optioning clear empties the log.
Flags	Displays the error log. This log contains any errors logged by the unit software. Pressing
	Menu when it appears displays the Clearall screen in which the user can clear all the logged
	errors.
Resets	Displays the Reset Error log. This log contains any errors logged when the user resets the
	unit during operation. The most recent reset appears at the top of the list. Pressing Menu
	when it appears displays the Clearall screen in which the user can clear all the logged errors.
Coin Cell	Displays the Charger and Battery Voltage.
CE Status	Indicates accessory type connected to unit.

6.1.3Entering Test Mode

Use this procedure to access test mode.

To enter test mode:

1. Power up the unit. Wait until the power-up sequence is complete before continuing.

NOTE: Steps 2 through 7 must be performed quickly (no more than one second between each key press).

2. Press #.

68P80400P73-A 6-3