27.Route the Lat Cable (71) over a 90mm Pulley
(39)and down through the Left Top Frame (8). Attach the Pulley inside the Top Frame with an
M10 x 80mm Bolt (111), two M10 Washers (116), two 19mm Spacers (77), and an M10 Nylon
Locknut (114).
28.Wrap the Let Cable (71) under a 90mm Pulley
(39).Attach the Pulley, a Small Cable Trap (48), and two Full Finger Guards (43) to the Dip Assist
(21)with an M10 x 232mm Bolt (108), three M10 Washers (116), two 40ram Spacers (74), and an M10 Nylon Locknut (114). Make sure the Cable
Trap is oriented as shown.
29.Attach the Let Cable (71) to the bracket on the Rear Upright (6) with an M8 x 22mm Shoulder Bolt (88) and an M8 Nylon Locknut (115). Make sure the flat edge of the Cable is against the bracket.
30.Locate the Ab Cable (72). Wrap the Cable over a 90mm Pulley (39). Attach the Pulley and the two Quarter Guards (95) to the Right Upright (4) with an M10 x 108mm Bolt (99), an M10 Washer (116), and an M10 Nylon Locknut (114). Make sure that the rod is inserted through both Quarter Guards and is over the Cable.
31.Wrap the Ab Cable (72) under a 90mm Pulley (39). Attach the Pulley and two Half Finger Guards (42) to the Double
Locknut (114). Make sure the Finger Guards are oriented as shown.
27
28 _ if _/
116
31
111
7 j
,_'_:'116
1_ | _o71 74 | I |
_.
72" _'_
14