10.Identify the Front Weight Guides (136), which have the lock holes closer to the center than the
Rear Weight Guides (24). Orient the Weight Guides with the holes closerto the bottom.
Attach the Front Weight Guides (136) to the Right Base (1) with an M10 x 155mm Bolt (130), two M10 Washers (116), and an M10 Nylon Locknut
Slide two Weight Bumpers (65) onto the Front Weight Guides (136). Slide the ten Weights (35), with the pin holes on the indicated side, onto the Weight Guides.
Press a Weight Tube Bumper (66) into the Long Weight Tube (36). Insert the Weight Tube intothe stack of Weights (35). Make sure the pin on the Weight Tube sits in the groove on the top Weight.
Grease the indicated holes in a Top Weight (34) with an included grease pack. Slide the Top
Weight onto the Front Weight Guides (136).
Repeat this step with the Rear Weight Guides
(24)and eight Weights (35).
11.Attach the Right Top Frame (7) to the Right Upright (4) with two M8 x 80mm Bolts (94), two M8 Washers (117), and two M8 Nylon Locknuts (115). Do not tighten the Locknuts yet.
Attach the Right Top Frame (7) to the Left Top Frame (8) with two M8 x 60mm Bolts (94), two M8 Washers (117), and two M8 Nylon Locknuts (115). Do not tighten the Locknuts yet.
10
136
Lock
Holes
\
L
24
11
7
115
130114
116
115
9