Sears 831.15403 user manual

Page 17

41.Wrap the Leg Lever Cable (70) under a 90mm Pulley (39). Attach the Pulley and two Half Finger

Guards (42) to the Right Base (1) with an M10 x 48mm Bolt (101) and an M10 Nylon Locknut (114). Make sure the Finger Guards are orient- ed as shown.

42.Wrap the Leg Lever Cable (70) over a 90mm Pulley (39). Attach the Pulley, a Small Cable Trap (48), and two Half Finger Guards (42) at the sec- ond hole from the bottom of the two Pulley Plates

(51)with an M10 x 52mm Bolt (102) and an M10 Nylon Locknut (114). Make sure the Cable Trap and Finger Guards are oriented as shown.

43.Wrap the Leg Lever Cable (70) under a 90mm Pulley (39). Attach the Pulley and two Half Finger Guards (42) to the =U"-bracketon the Right Base

(1)with an MI0 x 48mm Bolt (101) and an M10 Nylon Locknut (114). Make sure the Finger Guards are oriented as shown and are on the outside of the "U"-bracket.

44.Wrap the Leg Lever Cable (70) under a 90mm Pulley (39). Attach the Pulley, a Small Cable Trap (48), and two Half Finger Guards (42) to the bracket on the Right Base (1) with an MI0 x 52mm Bolt (102) and an M10 Nylon Locknut

(114). Make sure the Cable Trap and Finger

Guards are oriented as shown and that the

bracket is between the Pulley and the Finger Guard next to the Locknut.

45.Route the Leg Lever Cable (70) up through the Right Top Frame (7), over a115mm Pulley (41), and back down through the Top Frame. Attach the Pulley inside the Top Frame with an M10 x 80mm Bolt (111), two M10 Washers (116), two 19mm Spacers (77), and an M10 Nylon Locknut (114).

41//

114

1 39

42

42

7O

45

17

Image 17
Contents Weight System Exerciser Table of Contents Important Precautions Stack Assembled DimensionsHeight 82 Width 105 Depth 94 Left Side Press Arm Backrest PressAssembly 115 Frame Assembly115 Handles 115 130114 LockAttach the Front Weight Guides 136 to the Right 114 Ase 59r Cable Assembly O71 Trap is oriented as shownCable in the groove of the Pulley Right Upright 4 with an M10 x 68mm Bolt114 4O-IPage ?--W 116 j114 39 .e Seat Assembly Lock Plate must be able to pivot easily Pad Tubes Pin 83 into the Lock Plate 80 and the Leg Lever Changing the Weight SettingUsing the Lock Plate Locking the DIP Assist Adjusting the BackrestLocking the Weight Stack Top WeightCable Diagrams Page Tightening the Cables MaintenancePersonalizing Your Exercise Program Four Basic Types of WorkoutsWarming UP Working OUTStaying Motivated Muscle ChartM1O x 38mm Screw M1O x 8Omm Bolt M10 x 45mm Bolt M8 x 83mm BoltM10 x 89mm Bolt M10 x 1O3mm Bolt M6 x 22mm BoltM12 Nut M6LocknutM8 x 80mm Bolt M8 x 70ram BoltExploded DRAWINGmModel No Ro7o4A 69450 119 Jl,,o.I Qty Description City Description12ram Spacer Leg Bumper25mm Round Inner Cap Sears