56.Wrap the Press Cable (69) around a 90mm Pulley (39). Attach the Pulley, two Half Finger
Guards (42), a Small Cable Trap (48), and an
M10 Washer (116) to the Left Upright (5) with an M10 x 108mm Bolt (99), an M10 Washer (116), and an M10 Nylon Locknut (114). Make sure the
Cable Trap and Finger Guards ere oriented as shown.
57.Wrap the Press Cable (69) around a 90mm Pulley (39). Attach the Pulley, two Half Finger
Guards (42), a Small Cable Trap (48), and an M1O Washer (116) to the Press Frame (13) with an M10 x 135mm Bolt (98). Make sure the Cable
Trap and Finger Guards are oriented as shown.
58.Wrap the Press Cable (69) around a
(40).Attach the
(42), a Cable Trap (49), and an M10 Washer
(116)to the Left Upright (5) with an M10 x 68mm Bolt (93) and an M10 Nylon Locknut (114). Make sure the Cable Trap and Finger Guards are oriented as shown.
59.Wrap the Press Cable (69) around a 90mm Pulley (39). Attach the Pulley, two Half Finger Guards (42), a Small Cable Trap (48), and an
M10 Washer (116) to the Press Frame (13) with the M10 x 135mm Bolt (98) used in step 57 and an M10 Nylon Locknut (114). Make sure the
Cable Trap end Finger Guards are oriented as shown.
60.Wrap the Press Cable (69) under a 90mm Pulley
(39).Attach the Pulley, two M10 Washers (116), and two Half Finger Guards (42) to the Left Base
(2)with an M10 x 52mm Bolt (102) and an M10 Nylon Locknut (114). Make sure the Finger Guards are oriented as shown.
56
69
42
57
98116
42 114
39 .e/
30 116421
2O