S T E P 7 | C A B L E # 1 |
A
B
C
D E 
F
Thread the bolt on the end of the cable (the end with the permanent bolt affixed) to the header plate a minimum of 1”, after slipping the closed loop of the weight selector pin tether over the attached nuts. Remove the slotted bolt and nut from the opposite end of the cable. Route the cable through the following pulleys in the order specified: Over pulley A, under B, over C, over D, over E, over F, under G, and thread a minimum of 0.5” into floating pulley housing H (after reattaching the slotted bolt and nut). Tighten the nut against the pulley housing.
WA R N I N G : F a i l u r e t o t h r e a d t h e e n d s i n t h e s p e c i f i e d d i s t a n c e c a n r e s u l t i n s e r i o u s i n j u r y !
H
G
17