Before operating the television, you must connect an antenna or a 75 ohm CATV cable to the 75 ohm ter- | |||||
minal or the audio/video wire harness to the audio/video input jacks. No CATV cable, antenna, or adapter is | |||||
included. |
|
|
| Note: Due to an FCC requirement, analog signals will | |
HOW TO CONNECT AN ANTENNA |
|
| |||
Place an indoor an- |
|
|
| no longer be broadcast over the air after June 12, | |
| Outdoor | 2009. If you wish to view television signals through an | |||
tenna or an outdoor | Indoor | antenna after that date, you must have an antenna ca- | |||
combination | Combination | pable of receiving digital signals. Cable television will | |||
VHF/UHF antenna | Antenna | VHF/UHF | not be affected. |
| |
in the desired loca- |
| Antenna | HOW TO CONNECT AN EXTERNAL SOURCE | ||
tion. Outdoor anten- |
|
|
| ||
nas are subject to |
|
|
| USING A CATV CABLE |
|
weathering that can |
|
|
| Use a CATV cable to connect to an external source | |
reduce signal qual- |
|
|
| ||
ity. Inspect your |
|
|
| such as a cable box, satellite TV box, VCR, or analog | |
outdoor antenna |
|
|
| cable. |
|
and the |
|
|
| 1. Connect one end of a 75 ohm CATV cable to the | |
wiring before con- |
|
|
| ||
necting the an- |
|
|
| 75 ohm output jack on your external source. | |
tenna. |
|
|
| 2. Plug in the power cord of your external source. | |
75 Ohm CATV Cable |
|
|
| See your external source userʼs manual for proper | |
1. Connect the 75 ohm | 75 Ohm CATV Cable | grounding instructions. |
| ||
CATV cable from the | 3. Connect the 75 ohm CATV cable to the 75 ohm | ||||
antenna to the 75 |
|
|
| terminal on the treadmill frame near the power | |
ohm terminal on the |
|
|
| cord. See the drawing at the left. | |
treadmill frame near |
|
|
| HOW TO CONNECT AN EXTERNAL SOURCE | |
the power cord. | 75 Ohm Terminal | ||||
300 Ohm Flat Wire | USING THE AUDIO/VIDEO WIRE HARNESS | ||||
|
|
| Use the audio/video wire harness to connect to an ex- | ||
1. Connect the 300 | Screwdriver |
| ternal source such as a VCR or DVD player. | ||
| 1. Connect the three- |
| |||
ohm flat wire from | 300 | 115 | |||
the antenna to a 300 |
|
| pronged end of the | ||
ohm to 75 ohm |
|
| Ohm Flat | Audio/Video Wire |
|
adapter. |
|
| Wire | Harness (115) to your |
|
| 300 to 75 |
| external source. |
| |
| Ohm Adapter |
|
|
| |
2.Push the 300 ohm to 75 ohm adapter onto the 75 ohm terminal on the treadmill frame near the power cord.
300 to 75 Ohm Adapter
75 Ohm
Terminal
2.Plug in the power cord of your external source. See your external source userʼs manual for proper grounding instructions.
3.Connect the audio/video wire harness to the audio/video input jack on the treadmill frame near the power cord.
12