NordicTrack NTL01909.2 manual Problem The chest pulse sensor does not function properly

Page 33

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system.

PROBLEM: The console displays remain lit when you remove the key from the console

SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 28 to turn off the demo mode.

PROBLEM: The chest pulse sensor does not function properly

SOLUTION: a. If the chest pulse sensor does not function properly, see TROUBLESHOOTING on page 13.

PROBLEM: Television reception is poor

SOLUTION: a. Make sure that the television settings are set correctly. See HOW TO ADJUST THE TELEVISION SETTINGS on page 26.

b. For the digital television to operate properly, good reception is necessary. If you are using an an- tenna, make sure that it is properly connected and adjusted for optimal reception. (See HOW TO CONNECT AN ANTENNA on page 12.)

c.Check for the problems listed below and follow the applicable instructions.

•Ignition (black spots or horizontal streaks that appear or a picture that flutters or drifts)— Usually this is caused by interference from automobile ignition systems, neon lamps, electric drifts, or other electric appliances. Try changing the position of the treadmill or other electric appliances to correct the problem.

•Ghosts—Ghosts are caused by the television signal following two paths—one is the direct path and the other is reflected from tall buildings, hills, or other objects. Change the direction or po- sition of the antenna to improve reception.

•Blue Screen—If the treadmill is located in the fringe area of a television station where the sig- nal is weak, the picture may be of poor quality or a blue screen may appear. If the signal is weak, it may be necessary to install an external antenna to improve the picture.

•Fading—If blocks of the picture are missing, the picture moves around the screen, or the pic- ture disappears, the signal may be weak. Change the direction or position of the antenna to im- prove reception. Make sure the television settings are set correctly (see HOW TO ADJUST THE TELEVISION SETTINGS on page 26). Do not use a splitter.

Note: If one of these problems appears when the cable from a CATV company is connected, the problem may be caused by the cable company broadcast.

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Model No. NTL01909.2 Serial No QUESTIONS?Table of Contents Important Precautions Page Power Lines Ground Standoff Service Clamp Before YOU Begin Assembly Ful not to pinch the Upright Wire Harness Star Washers 90. Do not tighten the BoltsTighten the Bolts yet Tors are not Connected Properly Console MAY be Damaged When Power is Turned ON. Remove the wireAre pinched Tighten the six BoltsAttach the Left Upright Sleeve not shown to Console assembly in the same wayStorage Latch. Make sure to keep the Latch Cap inside the Storage Latch. AttachPage HOW to Connect AN External Source HOW to Connect AN AntennaUsing a Catv Cable Using the AUDIO/VIDEO Wire HarnessHOW to PUT on the Chest Pulse Sensor HOW to USE the Chest Pulse SensorCare and Maintenance TroubleshootingOperation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Features of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerTurn on the fan if desired Follow your progress with the displays. The matrix-When youHOW to USE AN Event Training Workout Select an event training workoutStart the walking belt HOW to USE a Preset Workout Select a preset workoutEnter your weight HOW to Create a Custom Workout HOW to USE a Custom Workout Insert an iFit card and select a workout HOW to USE AN Ifit CardStart the walking belt Scan for television channels Adjust the volumeSelect a television source Select the desired channelHOW to Replace the Batteries in the Remote Control HOW to Operate the Remote ControlHOW to Adjust the Television Settings Exit the Menu Scan and save channelsInformation Mode HOW to USE the Stereo Sound SystemHOW to Adjust the Cushioning System HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingImportant The treadmill is not Compatible with GFCI-equipped outletsSolution Problem ProblemProblem Television reception is poor Problem The chest pulse sensor does not function properlyProblem The television is not receiving a signal Problem The remote control does not function correctlyProblem The volume cannot be turned up Problem The television needs to be cleanedExercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Qty Description Part LIST-Model No. NTL01909.2Qty Description R0310A Exploded Drawing B-Model No. NTL01909.2 Exploded Drawing C-Model No. NTL01909.2 Exploded Drawing D-Model No. NTL01909.2 Exploded Drawing E-Model No. NTL01909.2 Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents