NordicTrack NTL01909.2 manual

Page 4

21. Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 7, and HOW TO FOLD AND MOVE THE TREADMILL on page 29.) You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

22. Do not change the incline of the treadmill by placing objects under the treadmill.

23. When folding or moving the treadmill, make sure that the storage latch is holding the frame securely in the storage position.

24. Inspect and properly tighten all parts of the treadmill regularly.

25. Never insert or drop any object into any DANGER:opening on the treadmill.

26.Always unplug the power cord immediately after use, before cleaning the treadmill, and before performing the main- tenance and adjustment procedures de- scribed in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only.

27.The treadmill is intended for in-home use only. Do not use the treadmill in any commer- cial, rental, or institutional setting.

28.Over exercising may result in serious injury or death. If you feel faint or if you experience pain while exercising, stop immediately and cool down.

29.Do not store the television in temperatures below -40° F (-40° C) or above 140° F (60° C). Do not operate the television in temperatures below 23° F (-5° C) or above 90° F (35° C).

30.To protect the treadmill and television during lightning storms, unplug the power cord from the wall outlet and disconnect the cable sys- tem. This will prevent damage due to light- ning and power line surges.

31.If an outside antenna or cable system is con- nected, be sure that the antenna or cable sys- tem is grounded to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No. 70-1984, pro- vides information with respect to proper grounding of the mast and supporting struc- ture, grounding of the lead-in wire to an an- tenna discharge unit, size of grounding con- ductors, location of antenna discharge unit, connection to grounding electrodes, and re- quirements for the grounding electrode.

32.An outside antenna system should not be lo- cated in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or cir- cuits. When installing an outside antenna sys- tem, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.

33.To reduce the risk of electric shock, do not re- move the cover or the back of the television. There are no user serviceable parts inside. Refer servicing to qualified service personnel.

4

Image 4
Contents QUESTIONS? Model No. NTL01909.2 Serial NoTable of Contents Important Precautions Page Power Lines Ground Standoff Service Clamp Before YOU Begin Assembly Star Washers 90. Do not tighten the Bolts Ful not to pinch the Upright Wire HarnessTighten the Bolts yet Power is Turned ON. Remove the wire Tors are not Connected Properly Console MAY be Damaged WhenAre pinched Tighten the six BoltsConsole assembly in the same way Attach the Left Upright Sleeve not shown toStorage Latch. Make sure to keep the Latch Cap inside the Storage Latch. AttachPage HOW to Connect AN Antenna HOW to Connect AN External SourceUsing a Catv Cable Using the AUDIO/VIDEO Wire HarnessHOW to USE the Chest Pulse Sensor HOW to PUT on the Chest Pulse SensorCare and Maintenance TroubleshootingHOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeFollow your progress with the displays. The matrix-When you Turn on the fan if desiredSelect an event training workout HOW to USE AN Event Training WorkoutStart the walking belt Select a preset workout HOW to USE a Preset WorkoutEnter your weight HOW to Create a Custom Workout HOW to USE a Custom Workout HOW to USE AN Ifit Card Insert an iFit card and select a workoutStart the walking belt Adjust the volume Scan for television channelsSelect a television source Select the desired channelHOW to Operate the Remote Control HOW to Replace the Batteries in the Remote ControlHOW to Adjust the Television Settings Scan and save channels Exit the MenuHOW to USE the Stereo Sound System Information ModeHOW to Adjust the Cushioning System HOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useImportant The treadmill is not Compatible with GFCI-equipped outletsProblem Solution ProblemProblem The chest pulse sensor does not function properly Problem Television reception is poorProblem The remote control does not function correctly Problem The television is not receiving a signalProblem The volume cannot be turned up Problem The television needs to be cleanedExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Part LIST-Model No. NTL01909.2 Qty DescriptionQty Description R0310A Exploded Drawing B-Model No. NTL01909.2 Exploded Drawing C-Model No. NTL01909.2 Exploded Drawing D-Model No. NTL01909.2 Exploded Drawing E-Model No. NTL01909.2 Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT