NordicTrack NTL01909.2 manual Problem The remote control does not function correctly

Page 34

PROBLEM: The remote control does not function correctly

SOLUTION: a. Make sure you are standing on the treadmill, holding the remote control near the television and pointing the remote control directly at the console.

b.If your remote control is still not functioning correctly, the batteries should be replaced; most re- mote control problems are the result of low batteries. See page 25 to replace the batteries.

PROBLEM: The television is not receiving a signal

SOLUTION: a. Make sure the correct TV or AV source is selected. See step 3 on page 24 to select a television source.

b. Make sure that the CATV cable, audio/video wire harness, or antenna is connected securely to the treadmill. See page 12.

c.Scan for broadcast or cable signals. See page 27 to scan for signals.

d.Due to an FCC requirement, analog signals will no longer be broadcast over the air after June 12, 2009. If you wish to view television signals through an antenna after this date, you must have an antenna capable of receiving digital signals. Cable television will not be affected.

PROBLEM: The volume is too loud or the television audio makes a crackling sound

SOLUTION: a. If the television audio makes a crackling sound when the volume is turned up, the volume is too loud. Press the Volume increase or decrease button on the remote control until the volume level is 80 percent. Once the volume reaches 80 percent, adjust the volume by pressing the Volume but- tons on the console only.

PROBLEM: The volume cannot be turned up

SOLUTION: a. If the volume cannot be turned up, the volume may have been adjusted with the remote control. Press the Volume increase or decrease button on the remote control until the volume level is 80 percent. Once the volume reaches 80 percent, adjust the volume by pressing the Volume buttons on the console only.

b.If there is no sound coming from the television, make sure the television audio is not muted.

c.If there is no sound coming from the television, make sure the audio wire is not plugged into the audio jack on the console.

PROBLEM: The television needs to be cleaned

SOLUTION: a. UNPLUG THE POWER CORD. To clean the television, wipe the television and screen using a soft cloth with a small amount of soft detergent. Do not use a polishing cloth, solvent, or any type of propellant or chemical detergent such as alcohol or benzene.

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents QUESTIONS? Model No. NTL01909.2 Serial NoTable of Contents Important Precautions Page Power Lines Ground Standoff Service Clamp Before YOU Begin Assembly Star Washers 90. Do not tighten the Bolts Ful not to pinch the Upright Wire HarnessTighten the Bolts yet Are pinched Power is Turned ON. Remove the wireTors are not Connected Properly Console MAY be Damaged When Tighten the six BoltsStorage Latch. Make sure to keep the Latch Console assembly in the same wayAttach the Left Upright Sleeve not shown to Cap inside the Storage Latch. AttachPage Using a Catv Cable HOW to Connect AN AntennaHOW to Connect AN External Source Using the AUDIO/VIDEO Wire HarnessCare and Maintenance HOW to USE the Chest Pulse SensorHOW to PUT on the Chest Pulse Sensor TroubleshootingHOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeFollow your progress with the displays. The matrix-When you Turn on the fan if desiredSelect an event training workout HOW to USE AN Event Training WorkoutStart the walking belt Select a preset workout HOW to USE a Preset WorkoutEnter your weight HOW to Create a Custom Workout HOW to USE a Custom Workout HOW to USE AN Ifit Card Insert an iFit card and select a workoutStart the walking belt Select a television source Adjust the volumeScan for television channels Select the desired channelHOW to Operate the Remote Control HOW to Replace the Batteries in the Remote ControlHOW to Adjust the Television Settings Scan and save channels Exit the MenuHOW to USE the Stereo Sound System Information ModeHOW to Adjust the Cushioning System HOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Important The treadmill is not TroubleshootingProblem The power turns off during use Compatible with GFCI-equipped outletsProblem Solution ProblemProblem The chest pulse sensor does not function properly Problem Television reception is poorProblem The volume cannot be turned up Problem The remote control does not function correctlyProblem The television is not receiving a signal Problem The television needs to be cleanedWorkout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencySuggested Stretches Part LIST-Model No. NTL01909.2 Qty DescriptionQty Description R0310A Exploded Drawing B-Model No. NTL01909.2 Exploded Drawing C-Model No. NTL01909.2 Exploded Drawing D-Model No. NTL01909.2 Exploded Drawing E-Model No. NTL01909.2 Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents