HEART RATE MONITORING
2.There are four options to handle heart rate input signals. Press the [SELECT] key to scroll through the options until you find the one option that suits your needs. Press the [ENTER] key to select that option.
“BOTH HR ON “ - allows either telemetry or contact heart rate signals to be detected. Once the console has detected a valid input signal it will lock out the opposite type of signal for the duration of the workout session. For example, if you start out using contact heart rate then you are limited to using only contact heart rate during your workout session, even if the signal is lost while performing the workout, and
“BOTH NOT LOCKED” - allows either telemetry or contact heart rate signals to be detected. Does not lock out a particular input signal for the entire workout. This option will detect either input signal during a workout session, but only one at a time, and only until the other signal terminates.
“TELEMETRY ONLY “ - locks out contact heart rate signals and will only detect telemetry signals.
“HAND ONLY “ - locks out telemetry signals and will only detect contact heart rate signals.
“BOTH HR OFF “ - turns off the ability to detect any signal at all. Used in rare situations where there is excessive interference with the heart rate signals. *This option disables the Constant HR program and the Fitness Test program.
Error Messages
Text line messages are only seen in the Constant Heart Rate and Fitness Test programs due to the design of the program that necessitates a valid heart rate signal during the program. For these programs, ensure that neither the “BOTH HR OFF” or the “HAND ONLY” option is set as a default option.
“CHECK HR BELT” - The heart rate signal has been missing for the last 30 seconds in telemetry signal detection.
“HR BELT NEEDED” - No telemetry belt signal has been sensed during the initial setup time.
Page 14