MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the exercise cycle regularly. To clean the exercise cycle, use a soft, damp cloth. Keep liquids away from the console and keep the console out of direct sunlight.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, you must first remove the right side shield. First, remove the indicated M4 x 25mm Screws (65) from the Left Side Shield (26).
65 | 26 |
| |
| 65 |
Next, turn the indicated M8 Nylon Locknut (31) until the Drive Belt (47) is properly tightened. Then, reattach the right side shield.
47 |
31 |
PULSE SENSOR TROUBLESHOOTING
If the chest pulse sensor does not function properly, see CHEST PULSE SENSOR TROUBLESHOOTING on pages 9 and 10. If the handgrip pulse sensor does not function properly, see step 5 on page 14.
Next, remove the indicated M5 x 25mm Screw (37) and M4 x 16mm Screws (57) from the Right Side Shield (27). Using an adjustable wrench, turn the Right Pedal (21) counterclockwise and remove it. Turn the Right Crank Arm (23) so that it is pointing toward the front of the exercise cycle, and then slide off the Right Side Shield.
| 57 |
| 23 |
| 21 |
27 | 57 |
37 |
|
26