Philips HB933, HB945 manual Relaxation and your health, Relax sessions how often and how long?

English

Duration of the tanning session	For persons with very sensitive	For persons with normal	For persons with less sensitive
for each separate part of the body	skin	sensitive skin	skin
3rd session	10-15 minutes	20-25 minutes	30-35 minutes*
4th session	10-15 minutes	20-25 minutes	30-35 minutes*
5th session	10-15 minutes	20-25 minutes	30-35 minutes*
6th session	10-15 minutes	20-25 minutes	30-35 minutes*
7th session	10-15 minutes	20-25 minutes	30-35 minutes*
8th session	10-15 minutes	20-25 minutes	30-35 minutes*
9th session	10-15 minutes	20-25 minutes	30-35 minutes*
10th session	10-15 minutes	20-25 minutes	30-35 minutes*

*) or longer, depending on your skin sensitivity.

Relaxation and your health

Warmth has a relaxing effect.Think of what a hot bath or lazing in the sunshine does to you.You can enjoy the same relaxing effect by selecting the relax function × or ‚.

Bear in mind the following when you have a relax session:

-Avoid getting too hot. Increase the distance between yourself and the lamps, if necessary.

-If your head gets too hot, cover it or move your body so that less heat is emitted towards your head.

-Close your eyes during a relax session.

-Do not let the relax session last too long (see section ‘Relax sessions: how often and how long?’).

Relax sessions: how often and how long?

If you want to pamper your muscles or joints or want to enjoy the relaxing warmth of the Innergize without getting a tan, only switch on the infrared lamps to get a deep relaxation. If you want to continue enjoying the Innergize’s warmth after your tanning session, switch on the infrared lamps only for a relax session.

You can take infrared relax sessions several times a day (e.g. 30 minutes in the morning and in the evening).

Preparing for use

,You can easily move and store the appliance in transport position (Fig. 2).

1 Put the appliance on the floor as shown in the figure (Fig. 3).

Make sure there is sufficient room on either side of the appliance to allow the legs to move outwards.

2Press the dual push button in the handgrip (1) and pull the stand slightly up (2).Then release the push button (Fig. 4).

On a smooth floor, the legs of the appliance automatically move outwards. If the floor is not smooth, e.g. a carpeted floor, you may have to put

your foot on one of the legs to allow the other leg to move outwards.

3Pull up the stand by the handgrip as far as it goes. (Fig. 5) The stand locks into position with a click.

4Turn the lamp unit in the direction indicated in the figure. (Fig. 6)

This requires some force at first. Push the lamp unit in the direction indicated until it locks into position with a click.

,You can only switch on the appliance for a tanning or relax session if the lamp unit is in the correct position.

5Push the legs of the appliance under the bed or sofa you intend to lie down on.The lamps for functions ¼ and × are on the marked side of the appliance (HB947/HB945 only). (Fig. 7)

6Press the release buttons in the recesses of the control panel and push the control panel upwards along the stand. Let go of the release buttons when the lamp unit is at the required height. (Fig. 8)

,The distance between the UV filters and your body must be 70cm.The distance between the UV filters and the surface on which you lie

(e.g. a bed) must be 90cm. (Fig. 9)

,Pull out the measuring tape to determine whether the appliance is at the required height. (Fig. 10)

,The measuring tape automatically rewinds when you operate the red tab. (Fig. 11)

Using the appliance Tanning or relaxing (HB933)

1Fully unwind the mains cord.

2Put the plug in the wall socket.

3Set the selector to the desired position (Fig. 12).

Choose ¥ if you want to tan your body.

Choose ‚ if you prefer a relax session.

4Consult the chapters ‘Tanning and your health’ and ‘Relaxation and your health’ for the correct tanning or relax time.

5Put on the protective goggles provided.

,Only use these protective goggles when you tan with a Philips tanning appliance. Do not use them for other purposes.

,The protective goggles comply with protection class II according to directive 89/686/EEC.

6Lie down straight below the lamp unit of the appliance.

7Set the timer to the appropriate time for the session. (Fig. 13)

Note:It can take a few seconds for the lamps to go on.This is normal.

,The appliance beeps during the last minute of the session.