Star Trac E-TBTe manual Step

Page 25

Step 29.

Next, plug-in the heart rate cable from the neck into the heart rate board connector on the dis- play.

Step 30.

Plug back the Heart rate ground cable into the quick disconnect tab on the display mount.

2

1

Step 31.

Plug the center console ground cable into the quick disconnect tab on the display mount.

Step 32.

Assemble the front and back display parts to- gether by sliding the bottom of the front display under the 2 tabs at the base first, then pressing front display against the back cover.

Caution: Be careful not to pinch any wires.

26	620-7921 Rev A

Image 25

Contents Work Instructions General Unpacking Instructions Verify the following tools are included in the kit Installation Instructions Step Rev a Step YOU have NOW Completed the Total Body Trainer Installation Rev a Embedded Display Console Installation Instructions Rev a Before After Step Step YOU have NOW Completed the Embedded Display Installation Rev a IPod Center Console Installation Instructions Now disconnect the heart rate connector from the display Step Step Step Before After Step Step YOU have NOW Completed the iPod Center Console Installation Rev a MYE Entertainment Center Console Installation Instructions Disconnect the 12-pin serial connector from the display Rev a Step Step Step Step YOU have NOW Completed the MYE Center Console Installation Rev a Personal Viewing Screen PVS Installation Instructions Now disconnect the heart rate connector from the display Screws Step Rev a Tie the iPod cable to the plastic using the 3.5 tie wrap Rev a From PVS Neck From Base Neck Tie Wrap Step Rev a Step Rev a Star Trac Star Trac FitnessTM Manager / Maintenance Mode PB-UB Troubleshooting