Star Trac E-TBTe manual Rev a

Page 42

Step 21.

Connect the center console keypad cable to J8 connector on the display board.

Step 23.

Now connect the iPod® cable from the bottom cover to J10 connector on the center console board.

43

Step 22.

Connect the seven-pin interface cable from the console to J14 connector on the display board.

Step 24.

Next replace the bottom cover. Use the screws saved from the earlier step to secure the display bottom. Tighten the screws so they are snug, then plug in the CSAFE power cable to the back of the display.

Note: Take special care to not pinch any of the ca- bles between the plastics.

620-7921 Rev A

Image 42

Contents Work Instructions General Unpacking Instructions Verify the following tools are included in the kit Installation Instructions Step Rev a Step YOU have NOW Completed the Total Body Trainer Installation Rev a Embedded Display Console Installation Instructions Rev a Before After Step Step YOU have NOW Completed the Embedded Display Installation Rev a IPod Center Console Installation Instructions Now disconnect the heart rate connector from the display Step Step Step Before After Step Step YOU have NOW Completed the iPod Center Console Installation Rev a MYE Entertainment Center Console Installation Instructions Disconnect the 12-pin serial connector from the display Rev a Step Step Step Step YOU have NOW Completed the MYE Center Console Installation Rev a Personal Viewing Screen PVS Installation Instructions Now disconnect the heart rate connector from the display Screws Step Rev a Tie the iPod cable to the plastic using the 3.5 tie wrap Rev a From PVS Neck From Base Neck Tie Wrap Step Rev a Step Rev a Star Trac Star Trac FitnessTM Manager / Maintenance Mode PB-UB Troubleshooting