Star Trac E-TBTe manual Step

Page 6

Step 5.

Using provided screwdriver, remove the M4 x

0.7screws that hold the display assembly to- gether, then separate the back of the display from the front.

Note: Retain the screws for later use.

Step 7.

Line up the four holes of the mounting bracket with holes of the neck, then insert four 6mm x 50mm socket head cap screws.

7

Step 6.

Slide the back of the display with the mounting bracket onto the upper neck of the Total Body Trainer.

Caution: Be careful not to pinch any cables between the two sections of the assembled neck

Step 8.

Using provided 5mm hex key, tighten down the screws to 240 in-lbs (27 N-m).

620-7921 Rev A

Image 6
Contents Work Instructions General Unpacking Instructions Verify the following tools are included in the kit Installation Instructions Step Rev a Step YOU have NOW Completed the Total Body Trainer Installation Rev a Embedded Display Console Installation Instructions Rev a Before After Step Step YOU have NOW Completed the Embedded Display Installation Rev a IPod Center Console Installation Instructions Now disconnect the heart rate connector from the display Step Step Step Before After Step Step YOU have NOW Completed the iPod Center Console Installation Rev a MYE Entertainment Center Console Installation Instructions Disconnect the 12-pin serial connector from the display Rev a Step Step Step Step YOU have NOW Completed the MYE Center Console Installation Rev a Personal Viewing Screen PVS Installation Instructions Now disconnect the heart rate connector from the display Screws Step Rev a Tie the iPod cable to the plastic using the 3.5 tie wrap Rev a From PVS Neck From Base Neck Tie Wrap Step Rev a Step Rev a Star Trac Star Trac FitnessTM Manager / Maintenance Mode PB-UB Troubleshooting