Star Trac E-TBTe manual Tie Wrap

Page 44

Tie Wrap

Step 29.

Take the 5” piece of tape from the PVS kit and wrap the connectors so that all of the metal sur- face is covered.

Step 31.

Plug-in the 12-pin main I/O cable coming from the unit base into the front display circuit board at J4 connector.

45

Step 30.

Using a 5” tie wrap from the PVS kit, bind the cables from the PVS neck to one side of the display mount. Take the tie and put it through the hole on one of the display mount tubes.

Step 32.

Next, plug-in the heart rate cable from the neck into the heart rate board connector on the dis- play.

620-7921 Rev A

Image 44

Contents Work Instructions General Unpacking Instructions Verify the following tools are included in the kit Installation Instructions Step Rev a Step YOU have NOW Completed the Total Body Trainer Installation Rev a Embedded Display Console Installation Instructions Rev a Before After Step Step YOU have NOW Completed the Embedded Display Installation Rev a IPod Center Console Installation Instructions Now disconnect the heart rate connector from the display Step Step Step Before After Step Step YOU have NOW Completed the iPod Center Console Installation Rev a MYE Entertainment Center Console Installation Instructions Disconnect the 12-pin serial connector from the display Rev a Step Step Step Step YOU have NOW Completed the MYE Center Console Installation Rev a Personal Viewing Screen PVS Installation Instructions Now disconnect the heart rate connector from the display Screws Step Rev a Tie the iPod cable to the plastic using the 3.5 tie wrap Rev a From PVS Neck From Base Neck Tie Wrap Step Rev a Step Rev a Star Trac Star Trac FitnessTM Manager / Maintenance Mode PB-UB Troubleshooting