Diagram 11 | Secure the |
|
| hood. |
|
| Slide the |
|
| hood under |
|
| the 2 screws |
|
| found on the |
|
| inboard side | 1 |
| of both | |
| upright |
|
| supports. |
|
2
3 |
4 |
CAUTION: Do not overtighten the screws or you may inadvertently cause stress cracks in the plastic hood.
13.Attach the hood. Diagram 11. Place the hood over the motor and slide it under the upper 4 screws (see Diagram 11 #1) and over the 2 lower screws (1 found on each side) of both upright supports.
As you lower the hood, slide the hood under the washers and onto the screws (2 in the front, 1 on either side of the treadmill). See Diagram 11, #2 and #3. Retighten the screws that you loosened in step 4. Be sure that the hood is sandwiched be- tween the base assembly and the washers. The washers must be on the outside of the hood. Tighten the screws securely using the hex key provided.
Diagram 12 | Level |
|
| the |
|
| unit. |
|
| 1 | 2 |
14.The M9.55 has adjustable rear feet. Check to make sure that the running surface is level (use a bubble level as shown in Diagram 12). If the treadmill is placed on a slightly, uneven surface, adjusting the rear feet can help, but will not compen- sate for extremely uneven surfaces.
page 16