Precor M9.55 owner manual Turning the Unit on and OFF, Foot

Diagram 13	Adjust
	the rear
	foot.

CAUTION: Ask for assistance to lift the rear of the unit slightly off the floor. Lift the unit by its side rails. Trying to lift the unit and adjust the rear foot without assistance may cause injury to yourself or damage to the unit. Do not try to lift the unit using the running belt.

Important: If you need to make adjustments, adjust one rear foot at a time. Do not use the rear foot to raise or lower the unit more than 1/4” in height. Check the level of the unit after each adjustment.

15.To adjust a rear foot, locate the nut that secures the rear foot to the deck. See Diagram 13. Loosen the nut with a crescent wrench or appropriate open-end wrench until you can easily turn the foot. See inset in Diagram 13.

16.To raise the rear deck, turn the foot clockwise and make the proper height adjustment. Then, retighten (counterclockwise) the nut securely using the wrench.

CAUTION: Never remove or bypass the

3-prong plug on the unit’s power cord with an adapter. Do not use a non-grounded outlet. Do not plug the treadmill into a power transformer in an attempt to adjust the voltage requirements.

Turning the Unit ON and OFF

Use the ON/OFF (I/O) power switch to turn the unit ON and OFF. This switch is located on the front of the unit, near the power cord.

The treadmill requires a dedicated circuit. Plug the power cord into a dedicated 20 amp, grounded, power source. Make sure that no other product or machine uses the same circuit as the treadmill.

To complete the installation of the treadmill, continue to Checking the Alignment of the Running Belt on the next page.

page 17