Weider 831.159821 user manual ARM Assembly, Butterfly Frame must be able to pivot easily

11.Press the two Weight Guide Bushings (44) into the Center Top Frame (14). Slide the Center Top Frame onto the Weight Guides (20).

Attach the Center Top Frame (14) to the Right

Top Frame (8) with two M10 x 70mm Bolts (81), two M10 Washers (75), and two M10 Nylon Locknuts (70).

Attach the Center Top Frame (14) to the Left Top

Frame (3) with two M10 x 70mm Bolts (81), two M10 Washers (75), and two M10 Nylon Locknuts (70).

Tighten all of the M10 Nylon Locknuts (70) used in steps 3–11.

ARM ASSEMBLY

12.Press a 38mm Square Inner Cap (41) into the Right Upright (6). Press a 50mm x 70mm Inner Cap (22) into the Butterfly Frame (9).

Lubricate an M10 x 80mm Bolt (61) with grease. Attach the Butterfly Frame (9) to the Right Top Frame (8) with the Bolt and an M10 Nylon Locknut (70). Do not overtighten the Locknut; the

Butterfly Frame must be able to pivot easily.

13.Lubricate an M10 x 50mm Bolt (62) with grease. Attach the Pivot Bracket (48) to the Right Butterfly Arm (11) with the Bolt and an M10 Nylon Locknut

(70). Do not overtighten the Locknut; the Pivot

Bracket must be able to pivot easily.

Press a 40mm x 50mm Inner Cap (23) into the indicated end of the Right Butterfly Arm (11). Wet the bottom end of the Arm with soapy water. Slide a Large Foam Pad (19) onto the Arm.

Slide a Foam Grip (76) onto a Press Handle (12). Press a 25mm Round Inner Cap (24) into the end of the Handle. Attach the Handle to the Right Butterfly Arm (11) with two M8 x 16mm Bolts (64) and two M8 Washers (26).

Slide the Large Foam Pad (19) down so that the bottom of the Foam Pad is even with the bottom of the Right Butterfly Arm (11).

Repeat this step with the Left Butterfly Arm (10).

9

11
			70	44	70
	14
	81	70			70		81
	75					75
8							75
		20					3
12					8
	22
					41
	70			Lubricate			6
					61
	9
13	Lubricate				62
					48
	64		11		23
				70
64	26
			24
	26					10
19
		76
	12