Weider WESY99300 Apply the Weider PRO 9930 decal in the location shown, Pro, Maintenance on

Page 18

39.Apply the WEIDER PRO 9930 decal in the location shown.

39

WEIDER

PRO 9930

40. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in

ADJUSTMENT, beginning on page 21 of this manual.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem.	IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAMS on pages 19 and 20 of this manual for proper cable routing. If there is any slack
in the cables, you will need to remove the slack by tightening the cables. See TROUBLE-SHOOTING
AND MAINTENANCE on page 22.

18

Image 18

Contents Model No. WESY99300 Serial No Our factoryTable of Contents Limited WarrantyKeep hands and feet away from moving parts Important PrecautionsRead all instructions in this manual New decal in the appropriate locationUsing the weight system Before YOU BeginAssembly Locate and open the parts bag labelled Frame Assembly Head of each BoltDo not tighten Nylon Locknuts yet Into the top of the Butterfly Top Frame Attach the Weight Guides 58 to the Butterfly BasePin Grooves 1717 4Lubricate Flat Washers 19, and two 5/16 Nylon LocknutsTwo 5/16 Nylon Locknuts ClosestTighten all nylon locknuts used in steps 1 through Press Base. This will be a tight fit Locate and open the parts bag labelled ARMBushings should fit onto the ends of the tube Locknut the Press Frame must pivot easilyIdentify the Short Cable 71. It has a closed loop on Nylon LocknutShown One end and a threaded shaft on the other Press Top FrameStep End and a loop on the other A 3/8 Nylon LocknutLocknut Butterfly BaseBase 61 with a 3/8 x 2 Bolt 35 and a 3/8 Nylon Locknut BracketEr Pulley will be attached to the Bolt Is oriented as shown Frame 52 with a 3/8 x 3 1/4 Bolt 28, a 3/8 FlatWasher 17, and a 3/8 Nylon Locknut Secure them with the Nylon LocknutLocate and open the parts bag labelled Seat Assembly Secure it with a 1/4 Flat Washer 11 and a 1/4 Nylon LocknutSeat 51 with two 1/4 x 3/4 Screws Apply the Weider PRO 9930 decal in the location shown ADJUSTMENT, beginning on page 21 of this manualMaintenance on PROCable Diagrams Cable ID Chart71 1.9m 6 ft 72 3.5m 11 ft 73 7.6m 24 ft Long Cable Cise will be reduced AdjustmentCable with two Cable Clips. Adjust the length Nylon Strap 56 can be attached in the same mannerTROUBLE-SHOOTING and Maintenance Ed, move the other PulleyWeight Resistance Chart High Arm Butterfly Curl Leg Raise Weight Pulley Press LbsPlates Lbs Top Ordering Replacement Parts Part No R0501ARemove this Part Identification Chart from the Manual R0501APart Identification CHART-Model No. WESY99300 X 1 1/2 Carriage Bolt Pulley 21 Not shown to scalePage Remove this Part LIST/EXPLODED Drawing from the Manual Qty Description Key No. Qty Long CableModel No. WESY99300