Weider WESY99300 user manual Remove this Part Identification Chart from the Manual, R0501A

Page 25

REMOVE THIS PART IDENTIFICATION

CHART FROM THE MANUAL

This chart is provided to help you identify the small parts used in assembly. The number in parenthesis below

each part refers to the key number of the part.Important: Some parts may have been pre-assembled for shipping purposes. If you cannot find a part in the parts bags, check to see if it has been pre-assembled.

Note: Assembly is divided into four stages: 1) frame assembly; 2) arm assembly; 3) cable and pulley assembly; and 4) seat assembly. The hardware for each assembly stage is packaged separately. Wait

until you begin each stage to open the parts bag for that stage.

R0501A

Image 25
Contents Our factory Model No. WESY99300 Serial NoLimited Warranty Table of ContentsRead all instructions in this manual Important PrecautionsKeep hands and feet away from moving parts New decal in the appropriate locationBefore YOU Begin Using the weight systemAssembly Head of each Bolt Locate and open the parts bag labelled Frame AssemblyDo not tighten Nylon Locknuts yet Pin Grooves 1717 4Lubricate Attach the Weight Guides 58 to the Butterfly BaseInto the top of the Butterfly Top Frame Flat Washers 19, and two 5/16 Nylon LocknutsClosest Two 5/16 Nylon LocknutsTighten all nylon locknuts used in steps 1 through Bushings should fit onto the ends of the tube Locate and open the parts bag labelled ARMPress Base. This will be a tight fit Locknut the Press Frame must pivot easilyNylon Locknut Identify the Short Cable 71. It has a closed loop onShown Press Top Frame One end and a threaded shaft on the otherStep Locknut A 3/8 Nylon LocknutEnd and a loop on the other Butterfly BaseBracket Base 61 with a 3/8 x 2 Bolt 35 and a 3/8 Nylon LocknutEr Pulley will be attached to the Bolt Washer 17, and a 3/8 Nylon Locknut Frame 52 with a 3/8 x 3 1/4 Bolt 28, a 3/8 FlatIs oriented as shown Secure them with the Nylon LocknutSecure it with a 1/4 Flat Washer 11 and a 1/4 Nylon Locknut Locate and open the parts bag labelled Seat AssemblySeat 51 with two 1/4 x 3/4 Screws Maintenance on ADJUSTMENT, beginning on page 21 of this manualApply the Weider PRO 9930 decal in the location shown PROCable ID Chart Cable Diagrams71 1.9m 6 ft 72 3.5m 11 ft 73 7.6m 24 ft Long Cable Cable with two Cable Clips. Adjust the length AdjustmentCise will be reduced Nylon Strap 56 can be attached in the same mannerEd, move the other Pulley TROUBLE-SHOOTING and MaintenanceHigh Arm Butterfly Curl Leg Raise Weight Pulley Press Lbs Weight Resistance ChartPlates Lbs Top Part No R0501A Ordering Replacement PartsR0501A Remove this Part Identification Chart from the ManualPart Identification CHART-Model No. WESY99300 Pulley 21 Not shown to scale X 1 1/2 Carriage BoltPage Remove this Part LIST/EXPLODED Drawing from the Manual Long Cable Qty Description Key No. QtyModel No. WESY99300