Miele G 7835 Opening and closing the door, Electric door lock, Opening the door

Page 11

Opening and closing the door

Electric door lock

The machine is equipped with an electric door lock.

The door can only be opened if:

the machine is connected to the electrical supply,

the ON/OFF button I-0is pressed, and

no wash program is running.

Opening the door

^Press the 5 door button, grasp the door handle and pull open the door.

,Do not touch the heating elements during or directly after the end of a program, you could burn yourself. They remain hot for some time after the end of the program.

To close the door

^Lift the door upwards and push until it clicks shut.

To open the door with the emergency release

The emergency release should only be used when the door cannot be opened normally, e.g. in the case of a power failure.

^ Turn the machine off with I-0.

^Reach up behind the service panel, located at the bottom of the machine, and pull the ring of the emergency release downwards.

,Do not use the emergency release when excessive temperatures have been reached in the cabinet. Danger of pressure wave release. Allow time for cooling.

11

Image 11
Contents Laboratory glassware washer G Contents Contents Use Important Safety InstructionsImportant Safety Instructions Important Safety Instructions Disposal of an old appliance Using accessoriesElectronic controls Guide to the machineCursor right Door switch h Start buttonDisplay On/Off button Cursor leftGuide to the machine To close the door Opening and closing the doorElectric door lock Opening the doorWater softener Softener Capacity Setting the water softenerSelect Unit Enter Water HardnessFilling the salt reservoir Salt indicator Mobile unit coding Automatic mobile unit recognition AWKMobile unit coding strip Setting mobile unit codingSet the program place coding Removing excess soils Preparing the items for cleaningApplications Loading the machineApplications Example upper basket O 190/1 and lower basket U Height adjustable top basketTo adjust the upper basket Spring adapter water connectionInjector unit 1/1 With connection to TA Laboratory glassware LGAdditional DOS modules optional Adding of liquid detergents and neutralizersPreparing the DOS dispensers Filling the containers with liquid cleaning agents Optional Dispensing system maintenancePriming the liquid dispensing systems External Dispensing systemsTo change the operating level Power switchOperation Turning onFree program selection Starting a programFixed program Automatic mobile unit recognition AWK Program sequenceTurning off Operating levels a or C To change or cancel a programOperating levels B or D Cancelling a program Serial interface Cleaning the coarse filter Cleaning and CareCleaning the filters in the wash cabinet Cleaning the fine, flat and micro-fine filters Tilt the locking clamp to the side Cleaning the drain pump and non-return valveCleaning the filter Cleaning the water inlet filtersCleaning the control panel Cleaning the exteriorOpen the door of the storage cabinet Drying unit TA Cleaning and careChanging the coarse filter Replacing the HEPA-Filter Frequently asked questions After sales service Page Installation Instructions Disposal of an old appliance Caring for the environmentDisposal of the packing materials Protecting the countertop depending on model InstallationLeveling the legs Removing the lid if necessaryWater inlet PlumbingDI-Water connection Drainage This Appliance Must be Grounded Electrical connectionGrounding the machine Re-assembling the service panelEnglish Metric Technical DataPage Page All rights reserved/3404