Miele G 7835 operating instructions Frequently asked questions

Page 38

Frequently asked questions

With the aid of the following guide, minor problems can be fixed without a service call.

Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage. In the event of any problems which cannot be corrected, please contact the Miele Technical Service Department.

Messages regarding the operating status of the machine and fault messages are shown in the display.

The error message table is supplied in the Programming manual under "Messages".

Heater limiter

This machine has a resettable heater limiter which will shut off the elements in the event of over-heating. This could be caused for example, if large articles cover the heating elements or if the filters in the wash cabinet are blocked.

If the message "CHECK WASH CABINET HEATING" is displayed (water has not heated up in the wash cabinet and the program takes too long):

^Isolate and correct the cause of the problem.

^Remove the service panel (see "Electrical connection").

^Press the red-brown RESET button on the temperature sensor on the right side.

If this switch trips repeatedly, contact the Miele Technical Service Department before using the machine further.

38

Image 38

Contents Laboratory glassware washer G Contents Contents Important Safety Instructions UseImportant Safety Instructions Important Safety Instructions Using accessories Disposal of an old applianceGuide to the machine Electronic controlsOn/Off button Cursor left Door switch h Start buttonDisplay Cursor rightGuide to the machine Opening the door Opening and closing the doorElectric door lock To close the doorWater softener Enter Water Hardness Setting the water softenerSelect Unit Softener CapacityFilling the salt reservoir Salt indicator Automatic mobile unit recognition AWK Mobile unit codingSetting mobile unit coding Mobile unit coding stripSet the program place coding Loading the machine Preparing the items for cleaningApplications Removing excess soilsApplications Spring adapter water connection Height adjustable top basketTo adjust the upper basket Example upper basket O 190/1 and lower basket ULaboratory glassware LG Injector unit 1/1 With connection to TAAdditional DOS modules optional Adding of liquid detergents and neutralizersPreparing the DOS dispensers Filling the containers with liquid cleaning agents External Dispensing systems Dispensing system maintenancePriming the liquid dispensing systems OptionalTurning on Power switchOperation To change the operating levelFree program selection Starting a programFixed program Automatic mobile unit recognition AWK Program sequenceTurning off Operating levels a or C To change or cancel a programOperating levels B or D Cancelling a program Serial interface Cleaning the coarse filter Cleaning and CareCleaning the filters in the wash cabinet Cleaning the fine, flat and micro-fine filters Cleaning the drain pump and non-return valve Tilt the locking clamp to the sideCleaning the exterior Cleaning the water inlet filtersCleaning the control panel Cleaning the filterOpen the door of the storage cabinet Drying unit TA Cleaning and careChanging the coarse filter Replacing the HEPA-Filter Frequently asked questions After sales service Page Installation Instructions Disposal of an old appliance Caring for the environmentDisposal of the packing materials Removing the lid if necessary InstallationLeveling the legs Protecting the countertop depending on modelPlumbing Water inletDI-Water connection Drainage Electrical connection This Appliance Must be GroundedRe-assembling the service panel Grounding the machineTechnical Data English MetricPage Page All rights reserved/3404