Miele G 7835 operating instructions Height adjustable top basket, Spring adapter water connection

Page 21

Applications

Spring adapter water connection

Make sure that the spring adapter for water connection engages correctly when a basket or injector unit is inserted in the machine. It must be 3/16" (4-5 mm) higher than the water connection inlet in the machine. If this is not the case, adjust the adapter.

^Loosen the lock ring.

^Push up the adapter (4-5 mm higher than the water connection inlet in the machine) and tighten up the lock ring.

Height adjustable top basket

The upper basket can be adjusted

above and below the middle position by 13/16" (2 cm).

Depending on the position of the upper basket and usage of an insert, items of the following height can be accommodated in the baskets:

Example upper basket O 190/1 and lower basket U 874

Upper

Upper

Lower

basket

basket

basket

position

height

height

 

 

 

Upper

max.

max.

 

7 7/8"

9 7/16"

 

(20 cm)

(24 cm)

Middle

max.

max.

 

8 11/16"

8 11/16"

 

(22 cm)

(22 cm)

Lower

max.

max.

 

9 7/16"

7 7/8"

 

(24 cm)

(20 cm)

To adjust the upper basket

^Pull out the top basket, lift from the runners and remove.

^Unscrew the knurled nuts (roller bearings) on both sides of the basket with a suitable wrench, reposition as required.

21

Image 21
Contents Laboratory glassware washer G Contents Contents Use Important Safety InstructionsImportant Safety Instructions Important Safety Instructions Disposal of an old appliance Using accessoriesElectronic controls Guide to the machineDisplay Door switch h Start buttonOn/Off button Cursor left Cursor rightGuide to the machine Electric door lock Opening and closing the doorOpening the door To close the doorWater softener Select Unit Setting the water softenerEnter Water Hardness Softener CapacityFilling the salt reservoir Salt indicator Mobile unit coding Automatic mobile unit recognition AWKMobile unit coding strip Setting mobile unit codingSet the program place coding Applications Preparing the items for cleaningLoading the machine Removing excess soilsApplications To adjust the upper basket Height adjustable top basketSpring adapter water connection Example upper basket O 190/1 and lower basket UInjector unit 1/1 With connection to TA Laboratory glassware LGAdding of liquid detergents and neutralizers Preparing the DOS dispensersAdditional DOS modules optional Filling the containers with liquid cleaning agents Priming the liquid dispensing systems Dispensing system maintenanceExternal Dispensing systems OptionalOperation Power switchTurning on To change the operating levelStarting a program Fixed programFree program selection Program sequence Turning offAutomatic mobile unit recognition AWK To change or cancel a program Operating levels B or DOperating levels a or C Cancelling a program Serial interface Cleaning and Care Cleaning the filters in the wash cabinetCleaning the coarse filter Cleaning the fine, flat and micro-fine filters Tilt the locking clamp to the side Cleaning the drain pump and non-return valveCleaning the control panel Cleaning the water inlet filtersCleaning the exterior Cleaning the filterDrying unit TA Cleaning and care Changing the coarse filterOpen the door of the storage cabinet Replacing the HEPA-Filter Frequently asked questions After sales service Page Installation Instructions Caring for the environment Disposal of the packing materialsDisposal of an old appliance Leveling the legs InstallationRemoving the lid if necessary Protecting the countertop depending on modelWater inlet PlumbingDI-Water connection Drainage This Appliance Must be Grounded Electrical connectionGrounding the machine Re-assembling the service panelEnglish Metric Technical DataPage Page All rights reserved/3404