Miele G 7835 operating instructions Electrical connection, This Appliance Must be Grounded

Page 47

Electrical connection

,All electrical work must be carried out by a qualified electrician in accordance with local and national safety regulations.

The machine comes equipped for connection to a 208 V, 60 Hz, 3 phase power supply. It is equipped with a 6 ft. (1.8 m) long, 12/4 AWG power cord, without a plug. A plug, rated for the required power which will fit the receptacle, is to be supplied by the electrician doing the installation. It should be connected to the main power supply.

Voltage:

208 V, 3 phase

Frequency:

60 Hz

Rated Load:

6 kW

Circuit breaker:

3 x 20 A

It can be converted to use a single phase power supply in accordance with the conversion and wiring diagram. The cord must be changed from a 12/4 AWG to a 10/3 AWG. Contact Miele Technical Service for more information.

Voltage:

208 V, 1 phase

Frequency:

60 Hz

Rated Load:

6 kW

Circuit breaker:

2 x 30 A

^A damaged power cord must only be replaced with a genuine Miele cord by a Miele service technician.

WARNING

THIS APPLIANCE MUST BE GROUNDED

Black : connect to L1 (hot)

Red: connect to L2 (hot)

White: connect to L3 (hot)

Green: connect to GND (ground)

47

Image 47
Contents Laboratory glassware washer G Contents Contents Use Important Safety InstructionsImportant Safety Instructions Important Safety Instructions Disposal of an old appliance Using accessoriesElectronic controls Guide to the machineCursor right Door switch h Start buttonDisplay On/Off button Cursor leftGuide to the machine To close the door Opening and closing the doorElectric door lock Opening the doorWater softener Softener Capacity Setting the water softenerSelect Unit Enter Water HardnessFilling the salt reservoir Salt indicator Mobile unit coding Automatic mobile unit recognition AWKMobile unit coding strip Setting mobile unit codingSet the program place coding Removing excess soils Preparing the items for cleaningApplications Loading the machineApplications Example upper basket O 190/1 and lower basket U Height adjustable top basketTo adjust the upper basket Spring adapter water connectionInjector unit 1/1 With connection to TA Laboratory glassware LGAdditional DOS modules optional Adding of liquid detergents and neutralizersPreparing the DOS dispensers Filling the containers with liquid cleaning agents Optional Dispensing system maintenancePriming the liquid dispensing systems External Dispensing systemsTo change the operating level Power switchOperation Turning onFree program selection Starting a programFixed program Automatic mobile unit recognition AWK Program sequenceTurning off Operating levels a or C To change or cancel a programOperating levels B or D Cancelling a program Serial interface Cleaning the coarse filter Cleaning and CareCleaning the filters in the wash cabinet Cleaning the fine, flat and micro-fine filters Tilt the locking clamp to the side Cleaning the drain pump and non-return valveCleaning the filter Cleaning the water inlet filtersCleaning the control panel Cleaning the exteriorOpen the door of the storage cabinet Drying unit TA Cleaning and careChanging the coarse filter Replacing the HEPA-Filter Frequently asked questions After sales service Page Installation Instructions Disposal of an old appliance Caring for the environmentDisposal of the packing materials Protecting the countertop depending on model InstallationLeveling the legs Removing the lid if necessaryWater inlet PlumbingDI-Water connection Drainage This Appliance Must be Grounded Electrical connectionGrounding the machine Re-assembling the service panelEnglish Metric Technical DataPage Page All rights reserved/3404