Miele G 7835 Program sequence, Turning off, Automatic mobile unit recognition AWK

Page 28

Operation

C. Automatic mobile unit recognition (AWK)

^Select operating level "C".

^Push the coded mobile unit into place (See Setting mobile unit coding").

^Close the door.

Important:

It is absolutely essential to check that the program required for this mobile unit is the one shown in the display, before starting the program by pressing the "Start" button. Otherwise inadequate cleaning could result.

Please make sure, that the places assigned for programs using AWK (Automatic mobile unit recognition) are not changed at random.

^Press the "Start" 6 button.

Document any program and dosage changes.

Program sequence

After being started the program will proceed automatically. It is finished when PROGRAM END appears in the display and the background lighting flashes (press any button to switch off the flashing lights).

The flashing lights can be permanently switched off. See "Programming Manual - System Functions".

Detailed information on program sequences is given in the appendix of the "Programming Manual".

The display background lighting goes out automatically after approximately 15 mins. To bring it back on again press one of the touch buttons.

Turning off

^Press in and release the ON-OFF, I-0, button.

^Turn off the water valves.

28

Image 28

Contents Laboratory glassware washer G Contents Contents Important Safety Instructions UseImportant Safety Instructions Important Safety Instructions Using accessories Disposal of an old applianceGuide to the machine Electronic controlsDoor switch h Start button DisplayOn/Off button Cursor left Cursor rightGuide to the machine Opening and closing the door Electric door lockOpening the door To close the doorWater softener Setting the water softener Select UnitEnter Water Hardness Softener CapacityFilling the salt reservoir Salt indicator Automatic mobile unit recognition AWK Mobile unit codingSetting mobile unit coding Mobile unit coding stripSet the program place coding Preparing the items for cleaning ApplicationsLoading the machine Removing excess soilsApplications Height adjustable top basket To adjust the upper basketSpring adapter water connection Example upper basket O 190/1 and lower basket ULaboratory glassware LG Injector unit 1/1 With connection to TAPreparing the DOS dispensers Adding of liquid detergents and neutralizersAdditional DOS modules optional Filling the containers with liquid cleaning agents Dispensing system maintenance Priming the liquid dispensing systemsExternal Dispensing systems OptionalPower switch OperationTurning on To change the operating levelFixed program Starting a programFree program selection Turning off Program sequenceAutomatic mobile unit recognition AWK Operating levels B or D To change or cancel a programOperating levels a or C Cancelling a program Serial interface Cleaning the filters in the wash cabinet Cleaning and CareCleaning the coarse filter Cleaning the fine, flat and micro-fine filters Cleaning the drain pump and non-return valve Tilt the locking clamp to the sideCleaning the water inlet filters Cleaning the control panelCleaning the exterior Cleaning the filterChanging the coarse filter Drying unit TA Cleaning and careOpen the door of the storage cabinet Replacing the HEPA-Filter Frequently asked questions After sales service Page Installation Instructions Disposal of the packing materials Caring for the environmentDisposal of an old appliance Installation Leveling the legsRemoving the lid if necessary Protecting the countertop depending on modelPlumbing Water inletDI-Water connection Drainage Electrical connection This Appliance Must be GroundedRe-assembling the service panel Grounding the machineTechnical Data English MetricPage Page All rights reserved/3404