Miele G 7835 operating instructions DI-Water connection

Page 45

Plumbing

DI-Water connection

The machine comes with a standard connection for a pressurized DI system. The recommended water pressure (flow rate) is 25 - 60 psi however, water pressure of 10 - 147 psi is acceptable.

^The DI pressure-tested hose (marked "H2O pure") with a 3/4" (2 cm) hose thread must be connected to the on-site water valve for DI purified water.

,If the DI water connection is not used, the electronics must be reprogrammed by a Miele technician. The water intake hose remains at the rear side of the machine.

45

Image 45

Contents Laboratory glassware washer G Contents Contents Use Important Safety InstructionsImportant Safety Instructions Important Safety Instructions Disposal of an old appliance Using accessoriesElectronic controls Guide to the machineDisplay Door switch h Start buttonOn/Off button Cursor left Cursor rightGuide to the machine Electric door lock Opening and closing the doorOpening the door To close the doorWater softener Select Unit Setting the water softenerEnter Water Hardness Softener CapacityFilling the salt reservoir Salt indicator Mobile unit coding Automatic mobile unit recognition AWKMobile unit coding strip Setting mobile unit codingSet the program place coding Applications Preparing the items for cleaningLoading the machine Removing excess soilsApplications To adjust the upper basket Height adjustable top basketSpring adapter water connection Example upper basket O 190/1 and lower basket UInjector unit 1/1 With connection to TA Laboratory glassware LGAdding of liquid detergents and neutralizers Preparing the DOS dispensersAdditional DOS modules optional Filling the containers with liquid cleaning agents Priming the liquid dispensing systems Dispensing system maintenanceExternal Dispensing systems OptionalOperation Power switchTurning on To change the operating levelStarting a program Fixed programFree program selection Program sequence Turning offAutomatic mobile unit recognition AWK To change or cancel a program Operating levels B or DOperating levels a or C Cancelling a program Serial interface Cleaning and Care Cleaning the filters in the wash cabinetCleaning the coarse filter Cleaning the fine, flat and micro-fine filters Tilt the locking clamp to the side Cleaning the drain pump and non-return valveCleaning the control panel Cleaning the water inlet filtersCleaning the exterior Cleaning the filterDrying unit TA Cleaning and care Changing the coarse filterOpen the door of the storage cabinet Replacing the HEPA-Filter Frequently asked questions After sales service Page Installation Instructions Caring for the environment Disposal of the packing materialsDisposal of an old appliance Leveling the legs InstallationRemoving the lid if necessary Protecting the countertop depending on modelWater inlet PlumbingDI-Water connection Drainage This Appliance Must be Grounded Electrical connectionGrounding the machine Re-assembling the service panelEnglish Metric Technical DataPage Page All rights reserved/3404