Miele G 7835 Setting the water softener, Select Unit, Enter Water Hardness, Softener Capacity

Page 13

Water softener

Setting the water softener

To program the water softener, go to the REACTIVATE menu.

After calling up the REACTIVATE menu the following appears in the display:

OPERATING INFORMATION REACTIVATE HARDNESS SETTING IN >°D <

WATER HARDNESS	19
SOFTENER CAPACITY	210 L OF 210 L

Select Unit

Select the type of unit you wish to use for setting the water hardness level:

^Activate the input position, select the type of unit e.g. mmol/l and confirm your choice.

OPERATING INFORMATION REACTIVATE HARDNESS SETTING IN >MMOL/L<

WATER HARDNESS	3.4
SOFTENER CAPACITY	170 L OF 210 L

Enter Water Hardness

After selecting the unit the water hardness value is in the display.

^Activate the input position, set the hardness level and confirm your selection.

OPERATING INFORMATION REACTIVATE

HARDNESS SETTING IN	>MMOL/L<
WATER HARDNESS	0.2
SOFTENER CAPACITY	170 L OF 700 L

Softener Capacity

You can see how much capacity the softener had left until it next needs to be reactivated.

13

Image 13

Contents Laboratory glassware washer G Contents Contents Use Important Safety InstructionsImportant Safety Instructions Important Safety Instructions Disposal of an old appliance Using accessoriesElectronic controls Guide to the machineDisplay Door switch h Start buttonOn/Off button Cursor left Cursor rightGuide to the machine Electric door lock Opening and closing the doorOpening the door To close the doorWater softener Select Unit Setting the water softenerEnter Water Hardness Softener CapacityFilling the salt reservoir Salt indicator Mobile unit coding Automatic mobile unit recognition AWKMobile unit coding strip Setting mobile unit codingSet the program place coding Applications Preparing the items for cleaningLoading the machine Removing excess soilsApplications To adjust the upper basket Height adjustable top basketSpring adapter water connection Example upper basket O 190/1 and lower basket UInjector unit 1/1 With connection to TA Laboratory glassware LGPreparing the DOS dispensers Adding of liquid detergents and neutralizersAdditional DOS modules optional Filling the containers with liquid cleaning agents Priming the liquid dispensing systems Dispensing system maintenanceExternal Dispensing systems OptionalOperation Power switchTurning on To change the operating levelFixed program Starting a programFree program selection Turning off Program sequenceAutomatic mobile unit recognition AWK Operating levels B or D To change or cancel a programOperating levels a or C Cancelling a program Serial interface Cleaning the filters in the wash cabinet Cleaning and CareCleaning the coarse filter Cleaning the fine, flat and micro-fine filters Tilt the locking clamp to the side Cleaning the drain pump and non-return valveCleaning the control panel Cleaning the water inlet filtersCleaning the exterior Cleaning the filterChanging the coarse filter Drying unit TA Cleaning and careOpen the door of the storage cabinet Replacing the HEPA-Filter Frequently asked questions After sales service Page Installation Instructions Disposal of the packing materials Caring for the environmentDisposal of an old appliance Leveling the legs InstallationRemoving the lid if necessary Protecting the countertop depending on modelWater inlet PlumbingDI-Water connection Drainage This Appliance Must be Grounded Electrical connectionGrounding the machine Re-assembling the service panelEnglish Metric Technical DataPage Page All rights reserved/3404