Miele PT 7136 PLUS installation manual Coin mechanism, Canceling a program, Continue drying

Page 15

Use

Coin mechanism

For coin mechanism operated machines: Money or tokens will be lost when the door is opened after program start or when canceling a program.

Technical Service can set a time frame when a program can be changed.

Canceling a program

Press the button "Cancel". The laundry is cooled down.

Press "Cancel" once more and "End" is displayed.

Press the button.

Open and close the door.

Select the new program.

Press the "Start" button.

Adding/removing laundry during a drying program

Press the button.

Open the door.

Do not touch the rear of the drum while adding or removing items. Danger of burns due to high temperatures in the drum.

Add or remove items.

Close the door.

Continue drying

Press the "Start" button.

Note

When the program cycle is changed the displayed remaining time may differ from the actual drying time.

15

Image 15

Contents Operating and Installation manual Vented Dryer PT 7136 Plus Contents Contents Important Safety Instructions Important Safety Instructions Save These Instructions Control panel Guide to the dryerProgram selection possibility Display functionMain menu Jog shuttleSettings Menu Program selectionBasic menu of a drying program Set the time of day Before using for the first timeWelcome screen LanguageUse Fabric care labelsDrying tips Load the laundry Sort the laundryStarting a program Select Low temp. and/or TimerSelect a program Insert coins if operated by coin mechanismBefore the end of a program Cleaning and care hintsAt the end of a program Remaining timeContinue drying Canceling a programCoin mechanism Adding/removing laundry during a drying programProgram guide Warm air Woollen handcareSmoothing Cool airProofing JeansNormal, Hand iron ShirtsCanceling the timer TimerSelect the submenu Timer Starting the timer functionFavorites Selecting/Changing a FavoriteBasic menu Drying level programs Program Warm air, Cool airOther programs Low temp Saving a FavoriteAssigning a direct select button Disassembling the lint filter Cleaning and CareCleaning the lint filter Removing the lint filterClean the lint filters wet Clean the lint filters dryInserting the lint filter Cleaning the exterior and the control panelFrequently asked questions Check and fault messages in the displayWhat if Possible cause Solution What if Possible cause Solution At the end of a ProgramAppears Other faults Items made What if Possible fault Solution What if there isCondensed water Drum?Display remains What if Possible cause Solution Program cannotStart indicator Be started,Changing the light bulb Optional accessories After sales serviceInstallation Instructions Important Safety Instructions Save These Instructions Front view InstallationSide view Rear view Top view Washer/ Dryer Stack Installation on a cement base Coin mechanism Installation Transporting the dryer to the installation siteLevel the dryer Electrical connection General notes Installation of exhaust ventingHow to calculate the effective duct length Tips about the ductwork Additional duct lengths 4 rigid pipe only Length Changing the position of the exhaust connection Determining the position of the exhaust connectionWall connection with rigid pipe Window connectionChimney connection Dryer top view Direct wall connectionCollective exhaust duct Technical Data Caring for the environment Disposal of the packing materialsDisposal of an appliance Menu Settings To adjust standard settings Leaving the Settings menu SettingsOpening the menu Settings Selecting SettingsNormal LanguageAnti-crease Time of day OffStandby Not during current program default settingDelivery status 0 minutes normal cooling down phase Contrast/BrightnessEntering the code Settings Supervisor levelSupervisor level Sort languagesLanguage entry Drying levels TimerCool air free Cleaning the airways Cleaning the lint filtersNormal Factory default Light Display the residual moisture as a percentagePage Page Page All rights reserved Nr 975 240