Miele PT 7136 PLUS Installation, Transporting the dryer to the installation site, Level the dryer

Page 39

Installation

Installation

Do not install a lockable or slide door in the pivoting area of the dryer door.

Transporting the dryer to the installation site

The rear overhang of the lid has transport grips.

Use the front dryer feet and the rear overhang to transport the dryer from the packaging base to the installation site.

Level the dryer

The dryer must be level to ensure safe and proper operation.

The machine can be leveled by turning the legs clockwise or counterclockwise as necessary.

An air gap of 3/8" (10 mm) must be provided between the machine and the floor. The vents must not be blocked by toe kicks, long piled carpet, etc.

The appliance is not intended to be mounted in a wall or other vertical surface of a building or cabinet. The unit is allowed for built-in application.

The machine may not be operated without the lid in place.

39

Image 39

Contents Operating and Installation manual Vented Dryer PT 7136 Plus Contents Contents Important Safety Instructions Important Safety Instructions Save These Instructions Control panel Guide to the dryerProgram selection possibility Display functionMain menu Jog shuttleSettings Menu Program selectionBasic menu of a drying program Set the time of day Before using for the first timeWelcome screen LanguageUse Fabric care labelsDrying tips Load the laundry Sort the laundryStarting a program Select Low temp. and/or TimerSelect a program Insert coins if operated by coin mechanismBefore the end of a program Cleaning and care hintsAt the end of a program Remaining timeContinue drying Canceling a programCoin mechanism Adding/removing laundry during a drying programProgram guide Warm air Woollen handcareSmoothing Cool airProofing JeansNormal, Hand iron ShirtsCanceling the timer TimerSelect the submenu Timer Starting the timer functionFavorites Selecting/Changing a FavoriteBasic menu Drying level programs Program Warm air, Cool airOther programs Low temp Saving a FavoriteAssigning a direct select button Disassembling the lint filter Cleaning and CareCleaning the lint filter Removing the lint filterClean the lint filters wet Clean the lint filters dryInserting the lint filter Cleaning the exterior and the control panelFrequently asked questions Check and fault messages in the displayWhat if Possible cause Solution What if Possible cause Solution At the end of a ProgramAppears Other faults Items made What if Possible fault Solution What if there isCondensed water Drum?Display remains What if Possible cause Solution Program cannotStart indicator Be started,Changing the light bulb Optional accessories After sales serviceInstallation Instructions Important Safety Instructions Save These Instructions Front view InstallationSide view Rear view Top view Washer/ Dryer Stack Installation on a cement base Coin mechanism Installation Transporting the dryer to the installation siteLevel the dryer Electrical connection General notes Installation of exhaust ventingHow to calculate the effective duct length Tips about the ductwork Additional duct lengths 4 rigid pipe only Length Changing the position of the exhaust connection Determining the position of the exhaust connectionWall connection with rigid pipe Window connectionChimney connection Dryer top view Direct wall connectionCollective exhaust duct Technical Data Caring for the environment Disposal of the packing materialsDisposal of an appliance Menu Settings To adjust standard settings Leaving the Settings menu SettingsOpening the menu Settings Selecting SettingsNormal LanguageAnti-crease Time of day OffStandby Not during current program default settingDelivery status 0 minutes normal cooling down phase Contrast/BrightnessEntering the code Settings Supervisor levelSupervisor level Sort languagesLanguage entry Drying levels TimerCool air free Cleaning the airways Cleaning the lint filtersNormal Factory default Light Display the residual moisture as a percentagePage Page Page All rights reserved Nr 975 240