Miele PT 7136 PLUS Opening the menu Settings, Selecting Settings, Leaving the Settings menu

Page 54

Settings ￿

Opening the menu Settings

1

Cottons

Program selection ...

 

2

Minimum iron

Settings ￿ ...

 

3

Woollens handcare

 

 

4

Smoothing

10:00

 

 

 

 

 

￿Select "Settings" ￿ in the main menu and confirm by pressing the jog shuttle.

Selecting Settings

Settings

Back ￿

Language ￿ ...

Anti-crease

Buzzer

￿

￿Select the setting to be changed and confirm.

If no selection is made in the submenu, the display will switch back to the "Settings" menu after 20 seconds.

Leaving the Settings menu

￿Select "Back" and confirm. The display shows the main menu.

54

Image 54
Contents Operating and Installation manual Vented Dryer PT 7136 Plus Contents Contents Important Safety Instructions Important Safety Instructions Save These Instructions Guide to the dryer Control panelJog shuttle Display functionMain menu Program selection possibilitySettings Menu Program selectionBasic menu of a drying program Language Before using for the first timeWelcome screen Set the time of dayUse Fabric care labelsDrying tips Sort the laundry Load the laundryInsert coins if operated by coin mechanism Select Low temp. and/or TimerSelect a program Starting a programRemaining time Cleaning and care hintsAt the end of a program Before the end of a programAdding/removing laundry during a drying program Canceling a programCoin mechanism Continue dryingProgram guide Cool air Woollen handcareSmoothing Warm airShirts JeansNormal, Hand iron ProofingStarting the timer function TimerSelect the submenu Timer Canceling the timerFavorites Selecting/Changing a FavoriteBasic menu Drying level programs Program Warm air, Cool airOther programs Low temp Saving a FavoriteAssigning a direct select button Removing the lint filter Cleaning and CareCleaning the lint filter Disassembling the lint filterClean the lint filters dry Clean the lint filters wetCleaning the exterior and the control panel Inserting the lint filterFrequently asked questions Check and fault messages in the displayWhat if Possible cause Solution What if Possible cause Solution At the end of a ProgramAppears Other faults Drum? What if Possible fault Solution What if there isCondensed water Items madeBe started, What if Possible cause Solution Program cannotStart indicator Display remainsChanging the light bulb After sales service Optional accessoriesInstallation Instructions Important Safety Instructions Save These Instructions Installation Front viewSide view Rear view Top view Washer/ Dryer Stack Installation on a cement base Coin mechanism Installation Transporting the dryer to the installation siteLevel the dryer Electrical connection Installation of exhaust venting General notesHow to calculate the effective duct length Tips about the ductwork Additional duct lengths 4 rigid pipe only Length Determining the position of the exhaust connection Changing the position of the exhaust connectionWindow connection Wall connection with rigid pipeChimney connection Direct wall connection Dryer top viewCollective exhaust duct Technical Data Caring for the environment Disposal of the packing materialsDisposal of an appliance Menu Settings To adjust standard settings Selecting Settings SettingsOpening the menu Settings Leaving the Settings menuOff LanguageAnti-crease Time of day NormalContrast/Brightness Not during current program default settingDelivery status 0 minutes normal cooling down phase StandbySettings Supervisor level Entering the codeSort languages Supervisor levelTimer Language entry Drying levelsDisplay the residual moisture as a percentage Cleaning the airways Cleaning the lint filtersNormal Factory default Light Cool air freePage Page Page All rights reserved Nr 975 240