Miele PT 7136 PLUS installation manual Settings Supervisor level, Entering the code

Page 57

Settings - Supervisor level

The menu "Settings - Supervisor level" is locked with a code to prevent unauthorized access (except Language ). It must be activated by Technical Service.

Settings

Supervisor level

Back

Access via code

Select "Access via code" and confirm.

Entering the code

Enter the code "0 0 0" (factory default).

If a wrong code is entered three times, the code entry will be locked for 1 hour.

0 _ _

Please enter code

Turn the jog shuttle until the first digit shows. Confirm the digit. Enter the second and third digits.

0		0	0

	Please confirm code


OK				Back

Confirm the code.

57

Image 57

Contents Operating and Installation manual Vented Dryer PT 7136 Plus Contents Contents Important Safety Instructions Important Safety Instructions Save These Instructions Control panel Guide to the dryerMain menu Display functionJog shuttle Program selection possibilitySettings Menu Program selectionBasic menu of a drying program Welcome screen Before using for the first timeLanguage Set the time of dayUse Fabric care labelsDrying tips Load the laundry Sort the laundrySelect a program Select Low temp. and/or TimerInsert coins if operated by coin mechanism Starting a programAt the end of a program Cleaning and care hintsRemaining time Before the end of a programCoin mechanism Canceling a programAdding/removing laundry during a drying program Continue dryingProgram guide Smoothing Woollen handcareCool air Warm airNormal, Hand iron JeansShirts ProofingSelect the submenu Timer TimerStarting the timer function Canceling the timerFavorites Selecting/Changing a FavoriteBasic menu Drying level programs Program Warm air, Cool airOther programs Low temp Saving a FavoriteAssigning a direct select button Cleaning the lint filter Cleaning and CareRemoving the lint filter Disassembling the lint filterClean the lint filters wet Clean the lint filters dryInserting the lint filter Cleaning the exterior and the control panelFrequently asked questions Check and fault messages in the displayWhat if Possible cause Solution What if Possible cause Solution At the end of a ProgramAppears Other faults Condensed water What if Possible fault Solution What if there isDrum? Items madeStart indicator What if Possible cause Solution Program cannotBe started, Display remainsChanging the light bulb Optional accessories After sales serviceInstallation Instructions Important Safety Instructions Save These Instructions Front view InstallationSide view Rear view Top view Washer/ Dryer Stack Installation on a cement base Coin mechanism Installation Transporting the dryer to the installation siteLevel the dryer Electrical connection General notes Installation of exhaust ventingHow to calculate the effective duct length Tips about the ductwork Additional duct lengths 4 rigid pipe only Length Changing the position of the exhaust connection Determining the position of the exhaust connectionWall connection with rigid pipe Window connectionChimney connection Dryer top view Direct wall connectionCollective exhaust duct Technical Data Caring for the environment Disposal of the packing materialsDisposal of an appliance Menu Settings To adjust standard settings Opening the menu Settings SettingsSelecting Settings Leaving the Settings menuAnti-crease Time of day LanguageOff NormalDelivery status 0 minutes normal cooling down phase Not during current program default settingContrast/Brightness StandbyEntering the code Settings Supervisor levelSupervisor level Sort languagesLanguage entry Drying levels TimerNormal Factory default Light Cleaning the airways Cleaning the lint filtersDisplay the residual moisture as a percentage Cool air freePage Page Page All rights reserved Nr 975 240