Miele PT 7136 PLUS installation manual Changing the light bulb

Page 31

Frequently asked questions

Changing the light bulb

To reduce the risk of electric shock, disconnect the appliance from the power supply by unplugging or tripping the circuit breaker.

Open the door.

The bulb cover is located along the upper rim of the drum opening.

Slide a screwdriver with a wide head underneath the side edge of the bulb cover and twist (see illustration).

Flip down the bulb cover.

Replace the light bulb with a temperature proof bulb available from Miele.

The light bulb must not exceed the maximum wattage listed on the data plate.

Replace the light bulb with a new one.

Flip the light bulb cover upwards and press it firmly into the left and right sides until it clicks into place.

Make sure the bulb cover is securely closed to prevent a short circuit from penetrating moisture.

31

Image 31

Contents Operating and Installation manual Vented Dryer PT 7136 Plus Contents Contents Important Safety Instructions Important Safety Instructions Save These Instructions Control panel Guide to the dryerProgram selection possibility Display functionMain menu Jog shuttleMenu Program selection SettingsBasic menu of a drying program Set the time of day Before using for the first timeWelcome screen LanguageFabric care labels UseDrying tips Load the laundry Sort the laundryStarting a program Select Low temp. and/or TimerSelect a program Insert coins if operated by coin mechanismBefore the end of a program Cleaning and care hintsAt the end of a program Remaining timeContinue drying Canceling a programCoin mechanism Adding/removing laundry during a drying programProgram guide Warm air Woollen handcareSmoothing Cool airProofing JeansNormal, Hand iron ShirtsCanceling the timer TimerSelect the submenu Timer Starting the timer functionSelecting/Changing a Favorite FavoritesBasic menu Program Warm air, Cool air Drying level programsOther programs Saving a Favorite Low tempAssigning a direct select button Disassembling the lint filter Cleaning and CareCleaning the lint filter Removing the lint filterClean the lint filters wet Clean the lint filters dryInserting the lint filter Cleaning the exterior and the control panelCheck and fault messages in the display Frequently asked questionsWhat if Possible cause Solution Program What if Possible cause Solution At the end of aAppears Other faults Items made What if Possible fault Solution What if there isCondensed water Drum?Display remains What if Possible cause Solution Program cannotStart indicator Be started,Changing the light bulb Optional accessories After sales serviceInstallation Instructions Important Safety Instructions Save These Instructions Front view InstallationSide view Rear view Top view Washer/ Dryer Stack Installation on a cement base Coin mechanism Transporting the dryer to the installation site InstallationLevel the dryer Electrical connection General notes Installation of exhaust ventingHow to calculate the effective duct length Tips about the ductwork Additional duct lengths 4 rigid pipe only Length Changing the position of the exhaust connection Determining the position of the exhaust connectionWall connection with rigid pipe Window connectionChimney connection Dryer top view Direct wall connectionCollective exhaust duct Technical Data Disposal of the packing materials Caring for the environmentDisposal of an appliance Menu Settings To adjust standard settings Leaving the Settings menu SettingsOpening the menu Settings Selecting SettingsNormal LanguageAnti-crease Time of day OffStandby Not during current program default settingDelivery status 0 minutes normal cooling down phase Contrast/BrightnessEntering the code Settings Supervisor levelSupervisor level Sort languagesLanguage entry Drying levels TimerCool air free Cleaning the airways Cleaning the lint filtersNormal Factory default Light Display the residual moisture as a percentagePage Page Page All rights reserved Nr 975 240