Miele PT 7136 PLUS installation manual Menu Settings To adjust standard settings

Page 53

Menu Settings

to adjust standard settings

The dryer controls can be adjusted to changing demands through the settings.

Depending on default settings:

–some settings are visible and can be changed by all users (Menu "Settings ")

or

–all setting are locked in the "Supervisor level" by a code (Menu "Settings - Supervisor level").

Contact Miele Technical Service.

Image 53

Contents Operating and Installation manual Vented Dryer PT 7136 Plus Contents Contents Important Safety Instructions Important Safety Instructions Save These Instructions Control panel Guide to the dryerMain menu Display functionJog shuttle Program selection possibilityBasic menu of a drying program SettingsMenu Program selection Welcome screen Before using for the first timeLanguage Set the time of dayDrying tips UseFabric care labels Load the laundry Sort the laundrySelect a program Select Low temp. and/or TimerInsert coins if operated by coin mechanism Starting a programAt the end of a program Cleaning and care hintsRemaining time Before the end of a programCoin mechanism Canceling a programAdding/removing laundry during a drying program Continue dryingProgram guide Smoothing Woollen handcareCool air Warm airNormal, Hand iron JeansShirts ProofingSelect the submenu Timer TimerStarting the timer function Canceling the timerBasic menu FavoritesSelecting/Changing a Favorite Other programs Drying level programsProgram Warm air, Cool air Assigning a direct select button Low tempSaving a Favorite Cleaning the lint filter Cleaning and CareRemoving the lint filter Disassembling the lint filterClean the lint filters wet Clean the lint filters dryInserting the lint filter Cleaning the exterior and the control panelWhat if Possible cause Solution Frequently asked questionsCheck and fault messages in the display Appears What if Possible cause Solution At the end of aProgram Other faults Condensed water What if Possible fault Solution What if there isDrum? Items madeStart indicator What if Possible cause Solution Program cannotBe started, Display remainsChanging the light bulb Optional accessories After sales serviceInstallation Instructions Important Safety Instructions Save These Instructions Front view InstallationSide view Rear view Top view Washer/ Dryer Stack Installation on a cement base Coin mechanism Level the dryer InstallationTransporting the dryer to the installation site Electrical connection General notes Installation of exhaust ventingHow to calculate the effective duct length Tips about the ductwork Additional duct lengths 4 rigid pipe only Length Changing the position of the exhaust connection Determining the position of the exhaust connectionWall connection with rigid pipe Window connectionChimney connection Dryer top view Direct wall connectionCollective exhaust duct Technical Data Disposal of an appliance Caring for the environmentDisposal of the packing materials Menu Settings To adjust standard settings Opening the menu Settings SettingsSelecting Settings Leaving the Settings menuAnti-crease Time of day LanguageOff NormalDelivery status 0 minutes normal cooling down phase Not during current program default settingContrast/Brightness StandbyEntering the code Settings Supervisor levelSupervisor level Sort languagesLanguage entry Drying levels TimerNormal Factory default Light Cleaning the airways Cleaning the lint filtersDisplay the residual moisture as a percentage Cool air freePage Page Page All rights reserved Nr 975 240