Kenmore 110.88732 manual Tools needed, MY-HOME If You Have You Will Need to Buy, Parts supplied

INSTALLATION INSTRUCTIONS

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools needed:.

Parts listed are available from your local Sears store or Sears Service Center. For further information, please call

1-800-4-MY-HOME® (1-800-469-4663).

If You Have You Will Need to Buy

Flat-blade screwdriver

Adjustable wrench that opens to 1" (2.5 cm) or %6" open-end wrench (for adjusting dryer feet)

Pliers that open to 1%6" (3.95 cm)

_A" nut driver or socket

wrench (recommended)

Tin snips (new vent installations)

Parts supplied:

•Caulking gun and compound (for installing new exhaust vent)

•Knife

•Vent clamps

•Wood block (for leveling)

•Level

•Tape measure

Laundry tub or		Sump pump system (if not already
standpipe	taller than	available)
96" (2.4 m)
1" (2.5 cm) diameter		2" (5 cm) diameter		to	1" (2.5 cm)
standpipe		diameter	standpipe	adapter, Part
		Number	3363920
Overhead	sewer	Standard	20 gal. (76 L) 34" (86.4 cm)
		tall drain tub or utility sink and sump
		pump (available from local plumbing
		suppliers)
Floor drain		Siphon break, Part Number 285320,
		additional drain hose, Part Number
		285702 and connector			kit,

Remove parts package from the washer basket. Check that all parts were included.

			G
A. Water inlet hoses (2)			E. Plastic	strap
B. Inlet hose flat	washers (4)		R Drain	hose
C. Rear leveling	legs	(2)	G. Yellow, single wire		hose	clamp
D. Front leveling	legs	(2)	H. Silver,	double-wire	hose	clamp

		Part Number		285442
Drain hose	too short	Drain hose,		Part Number		285664 and
		connector kit, Part Number 285442
Lint clogged	drain	Drain protector,			Part Number 367031
Water faucets		2 longer	water		fill hoses:
beyond reach of fill		6 ft (1.8	m) Part Number			76314,
hoses		10 ft (3.0 m) Part Number				350008

Parts needed:

Check local codes, electrical supply and venting, and read "Electrical Requirements" and "Venting Requirements" before purchasing parts.

Mobile home installations require metal exhaust system hardware available for purchase from your local Sears store or Sears Service Center. For further information, please call 1-800-4-MY-HOME® (1-800-469-4663).

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Do not dry anything that has ever had anything flammable on it (even after washing).

Failure to follow these instructions can result in death, explosion, or fire.

You will need

•A location that allows for proper exhaust installation. See "Venting Requirements."

A 120 volt, 60 Hz., AC only, 15- or 20-amp circuit.

A grounded electrical outlet located within 2 ft (61 cm) of either side of the laundry center. See "Electrical Requirements."