Install the front leveling legs

1.Examine the front leveling legs. Find the diamond marking,

2.Screw front legs by hand, into the holes in the triangular braces in the front corners. Use wrench to finish turning the legs until the diamond marking is no longer visible,

3.Gently stand the laundry center upright.

_S_eJnov@ ;_earn Rsc_{ sq

.........._s

1.Open the washer lid. The latch under the dryer will keep the lid open.

2.Pull the foam packing ring out of the washer.

NOTE: Keep the foam ring and use it when transporting your laundry center. This packing material is used to keep the washer tub stable during transport.

5.Place clamp over the area marked "CLAMR" Release clamp.

For laundry tub or standpipe drain systems

1.Open the yellow, single-wire clamp and slide over the hooked end of the drain hose to secure the rubber and corrugated sections together.

A. Hooked end

B. Drain hose

2.Put the hooked end of drain hose into laundry tub or standpipe. Rotate hook to eliminate kinks.

To prevent drain water from going back into the washer:

•Do not straighten hooked end of the drain hose and force excess drain hose into standpipe. Hose should be secure but loose enough to provide a gap for air.

•Do not lay excess hose on the bottom of the laundry tub.

For use with floor drain

Remove the drain hose hook from the corrugated drain hose. You

may need additional parts. See Floor drain under "Alternate Parts."

Ii} 'a bose

Proper connection of the drain hose protects your floors from damage due to water leakage. To prevent the drain hose from coming off or leaking, it must be installed according to the following instructions:

IMPORTANT." To ensure proper installation, this procedure must be followed exactly.

1.Check the drain hose to see whether it is the proper length.

2.Wet the inside of the straight end of the drain hose with tap water.

IMPORTANT: De not use any lubricant other than water.

3.Squeeze ears of the silver, double-wire clamp with pliers to open. Place clamp over the straight end of the drain hose W' (6,4 mm) from the end.

4.Open clamp. Twist hose back and forth while pushing onto drain connector on the side of the laundry center. Continue until hose contacts the ribbed stops on the cabinet.

Insert a new flat washer (supplied) into each end of the inlet hoses. Firmly seat the washers in the couplings.

ACoupling B. Washer

Connect the inlet hoses to the water faucets

Make sure the washer basket is empty.

2.Attach the hose labeled hot to the hot water faucet. Screw on coupling by hand until it is seated on the washer.

3.Attach the hose labeled cold to the cold water faucet. Screw on coupling by hand until it is seated on the washer.

4.Using pliers, tighten the couplings with an additional two- thirds turn.

NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can result.

Clear the water lines

•Run water through both faucets and inlet hoses, into a laundry tub, drainpipe or bucket to get rid of particles in the water lines that might clog the inlet valve screens,