Alliance Laundry Systems P232156R9 manual UW Models With M30 Control

Page 33

UW Models With M30 Control

1.When display shows a cycle number, the washer- extractor is ready to be loaded with laundry.

2.Press the STOP/UNLOCK button located on the control. Refer to Figure 14.

PHM758N

Figure 14

3.Open door within five seconds of pressing the door unlock keypad.

4.Turn the door handle clockwise and swing the door left to open it. The door must be opened within 5 seconds of pressing the door unlock button. Refer to Figure 15.

PHM593N

Figure 15

Basic Installation/Operation

5.Load the washer-extractor to full capacity whenever possible, but do not exceed the rated dry-weight capacity of the machine if the fabric to be washed is quite dense, closely woven, and heavily soiled.

Overloading can result in an inferior wash. The operator may need to experiment to determine load size based on fabric content, soil content and level of cleanliness required. Do not underload the machine. Underloading can result in premature bearing and sealing failure and out-of- balance situations.

PHM590N

Figure 16

F232156

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

31

Image 33

Contents Washer-Extractors Page Contents Important Safety Instructions Explanation of Safety MessagesBasic Installation/Operation Safety Decals Operator Safety Specifications 100 125 150 Overall Dimensions General SpecificationsWeight And Shipping Information UW UniLinc and M30 Control ModelsDrive Train Information Door Opening InformationCylinder Speeds / Centrifugal Force Data Balance DetectionElectrical Heating Optional Power Consumption UW A-Control, Variable-Speed ModelsWater Consumption MED UW P-Control, Variable-Speed Models Uwpv Models Specifications 100 125 150 Overall DimensionsWash/reverse, RPM / g Distribution, RPM / g Domestic shipping volume, ft.3 m3 UW 2 Speed Models UW35 UW60 Overall DimensionsCylinder Speeds/Centrifugal Force Data UW 3 Speed Models with P-Control or UW 3 Speed Models UW35 UW60 Overall Dimensions597 561 Crush hazard UniLinc and M30 Control Models100 125 150 911 14 UW150TV Uwav Models Models UW 35 Uwpv Models Uwpv Pocket Hardmount Machine Dimensions Refer to and FigureUW35PV UW125PV UW150PV 55.5 1410 64.5 1638 30.5 775 914 203 15.5 394 43.88 UW 2 Speed Models UW 3 Speed Models with P-Control or S-Control UW 3 Speed Models UW Models With UniLinc Control OperationFor Technical Service Distributor ABC UW Models With M30 Control Cycle Number Cycle Name PHM784N UW Models with S-Control Cycle is complete when display reads donE UW Models with P-Control Pre-Operating InstructionsOperating Instructions UW150 Models SW025 UW Models with A-Control Basic Installation/Operation UW Models with B-Control Basic Installation/Operation Disposal of Unit