Alliance Laundry Systems P232156R9 manual Operator Safety

Page 7

Operator Safety

WARNING

NEVER insert hands or objects into basket until it has completely stopped. Doing so could result in serious injury.

SW012

To ensure the safety of machine operators, the following maintenance checks must be performed daily:

1.Prior to operating the machine, verify that all warning signs are present and legible. Missing or illegible signs must be replaced immediately. Make certain that spares are available.

2.Check door interlock before starting operation of the machine:

a.Attempt to start the machine with the door open. The machine should not start with the door open.

b.Close the door without locking it and attempt to start the machine. The machine should not start with the door unlocked.

c.Close and lock the door and start a cycle. Attempt to open the door while the cycle is in progress. The door should not open.

If the door lock and interlock are not functioning properly, call a service technician.

3.Do not attempt to operate the machine if any of the following conditions are present:

a.The door does not remain securely locked during the entire cycle.

b.Excessively high water level is evident.

c.Machine is not connected to a properly grounded circuit.

Basic Installation/Operation

Do not bypass any safety devices in the machine.

WARNING

Never operate the machine with a bypassed or disconnected balance system. Operating the machine with severe out-of-balance loads could result in personal injury and serious equipment damage.

SW039

F232156

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Washer-Extractors Page Contents Important Safety Instructions Explanation of Safety MessagesBasic Installation/Operation Safety Decals Operator Safety UW UniLinc and M30 Control Models General SpecificationsSpecifications 100 125 150 Overall Dimensions Weight And Shipping InformationBalance Detection Door Opening InformationDrive Train Information Cylinder Speeds / Centrifugal Force DataElectrical Heating Optional UW A-Control, Variable-Speed Models Power ConsumptionWater Consumption MED UW P-Control, Variable-Speed Models Uwpv Models Specifications 100 125 150 Overall DimensionsWash/reverse, RPM / g Distribution, RPM / g Domestic shipping volume, ft.3 m3 UW 2 Speed Models UW35 UW60 Overall DimensionsCylinder Speeds/Centrifugal Force Data UW 3 Speed Models with P-Control or UW 3 Speed Models UW35 UW60 Overall Dimensions597 561 UniLinc and M30 Control Models Crush hazard100 125 150 911 14 UW150TV Uwav Models Models UW 35 Uwpv Models Uwpv Pocket Hardmount Machine Dimensions Refer to and FigureUW35PV UW125PV UW150PV 55.5 1410 64.5 1638 30.5 775 914 203 15.5 394 43.88 UW 2 Speed Models UW 3 Speed Models with P-Control or S-Control UW 3 Speed Models UW Models With UniLinc Control OperationFor Technical Service Distributor ABC UW Models With M30 Control Cycle Number Cycle Name PHM784N UW Models with S-Control Cycle is complete when display reads donE Pre-Operating Instructions UW Models with P-ControlOperating Instructions UW150 Models SW025 UW Models with A-Control Basic Installation/Operation UW Models with B-Control Basic Installation/Operation Disposal of Unit
Top Page Image Contents