Alliance Laundry Systems P232156R9 manual UW Models with B-Control

UW Models with B-Control

1.When display shows “----,” washer-extractor is ready to be loaded with laundry.

2.Use left hand to press and hold the door unlock button located on the lower right front of the control panel. Refer to Figure 28.

	NORMAL	PERM PRESS
WASH	HOT	HOT
ADD	LIGHT SOIL	VISA
BLEACH		WARM
RINSE	HOT
	HEAVY SOIL	UNIFORMS
SPIN	START
DOOR	HOT	HOT
	STAINED	DELICATE
	HOT	COLD

PHM601N

Figure 28

3.Use right hand to turn door handle clockwise and swing the door left to open. Refer to Figure 29.

PHM593N

Figure 29

Basic Installation/Operation

4.Load the washer-extractor to full capacity whenever possible, but do not exceed the rated dry-weight capacity of the machine if the fabric to be washed is quite dense, closely woven, and heavily soiled.

Overloading can result in an inferior wash. The operator may need to experiment to determine load size based on fabric content, soil content, and level of cleanliness required. Do not underload the machine. Underloading can result in premature bearing and sealing failure and out- of-balance situations.

WARNING

PHM590N

Figure 30

WARNING

Do not operate machine in a cycle with program keymode switch in program position. Program keymode switch must be in run position at all times, except when editing or programming cycle or setup information.

W528

WARNING

Do not operate machine in a cycle or if spinning with program keymode switch in program position.

W529

F232156 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 41