Alliance Laundry Systems P232156R9 manual UW Models with A-Control

Page 41

UW Models with A-Control

1.When display shows “Cyxx,” washer-extractor is ready to be loaded with laundry.

2.Use left hand to press and hold the door unlock button located on the lower right front of the control panel. Refer to Figure 25.

1	2
3	4
5	6
	<
	<

PHM626N

Figure 25

3.Use right hand to turn door handle clockwise and swing the door left to open. Refer to Figure 26.

PHM593N

Figure 26

Basic Installation/Operation

4.Load the washer-extractor to full capacity whenever possible, but do not exceed the rated dry-weight capacity of the machine if the fabric to be washed is quite dense, closely woven, and heavily soiled.

Overloading can result in an inferior wash. The operator may need to experiment to determine load size based on fabric content, soil content, and level of cleanliness required. Do not underload the machine. Underloading can result in premature bearing and sealing failure and out- of-balance situations.

WARNING

PHM590N

Figure 27

WARNING

Do not operate machine in a cycle with program keymode switch in program position. Program keymode switch must be in run position at all times, except when editing or programming cycle or setup information.

W528

WARNING

Do not operate machine in a cycle or if spinning with program keymode switch in program position.

W529

F232156

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

39

Image 41

Contents Washer-Extractors Page Contents Important Safety Instructions Explanation of Safety MessagesBasic Installation/Operation Safety Decals Operator Safety Specifications 100 125 150 Overall Dimensions General SpecificationsWeight And Shipping Information UW UniLinc and M30 Control ModelsDrive Train Information Door Opening InformationCylinder Speeds / Centrifugal Force Data Balance DetectionElectrical Heating Optional Water Consumption Power ConsumptionUW A-Control, Variable-Speed Models MED UW P-Control, Variable-Speed Models Uwpv Models Specifications 100 125 150 Overall DimensionsWash/reverse, RPM / g Distribution, RPM / g Domestic shipping volume, ft.3 m3 UW 2 Speed Models UW35 UW60 Overall DimensionsCylinder Speeds/Centrifugal Force Data UW 3 Speed Models with P-Control or UW 3 Speed Models UW35 UW60 Overall Dimensions597 561 100 125 150 Crush hazardUniLinc and M30 Control Models 911 14 UW150TV Uwav Models Models UW 35 Uwpv Models Uwpv Pocket Hardmount Machine Dimensions Refer to and FigureUW35PV UW125PV UW150PV 55.5 1410 64.5 1638 30.5 775 914 203 15.5 394 43.88 UW 2 Speed Models UW 3 Speed Models with P-Control or S-Control UW 3 Speed Models UW Models With UniLinc Control OperationFor Technical Service Distributor ABC UW Models With M30 Control Cycle Number Cycle Name PHM784N UW Models with S-Control Cycle is complete when display reads donE Operating Instructions UW Models with P-Control Pre-Operating Instructions UW150 Models SW025 UW Models with A-Control Basic Installation/Operation UW Models with B-Control Basic Installation/Operation Disposal of Unit