Alliance Laundry Systems P232156R9 manual UW Models with S-Control

Page 36

Basic Installation/Operation

UW Models with S-Control

1.Turn on the main power source (circuit breaker or cut-off switch on the wall).

2.Use left hand to press and hold the Door Unlock button located on the lower right front of the control panel. Refer to Figure 18.

MD003J

Figure 18

3.Use right hand to turn door handle clockwise, and swing the door left to open. Refer to Figure 19.

MD004J

Figure 19

4.Load the machine to full capacity whenever possible. DO NOT OVERLOAD.

PHM590N

Figure 20

CAUTION

Be careful around the open door, particularly when loading from a level below the door. Impact with door edges can cause personal injury.

SW025

NOTE: When washing items which may disintegrate or fragment, such as mop heads or sponges, use laundry nets to prevent drain blockage.

5.Close door and turn handle counterclockwise. Door will lock automatically.

CAUTION

Check the door safety interlock daily before the machine is placed in operation.

SW024

34

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F232156

Image 36

Contents Washer-Extractors Page Contents Explanation of Safety Messages Important Safety InstructionsBasic Installation/Operation Safety Decals Operator Safety General Specifications Specifications 100 125 150 Overall DimensionsWeight And Shipping Information UW UniLinc and M30 Control ModelsDoor Opening Information Drive Train InformationCylinder Speeds / Centrifugal Force Data Balance DetectionElectrical Heating Optional Power Consumption UW A-Control, Variable-Speed ModelsWater Consumption MED Uwpv Models Specifications 100 125 150 Overall Dimensions UW P-Control, Variable-Speed ModelsWash/reverse, RPM / g Distribution, RPM / g UW 2 Speed Models UW35 UW60 Overall Dimensions Domestic shipping volume, ft.3 m3Cylinder Speeds/Centrifugal Force Data UW 3 Speed Models UW35 UW60 Overall Dimensions UW 3 Speed Models with P-Control or597 561 Crush hazard UniLinc and M30 Control Models100 125 150 911 14 UW150TV Uwav Models Models UW 35 Uwpv Pocket Hardmount Machine Dimensions Refer to and Figure Uwpv ModelsUW35PV UW125PV UW150PV 55.5 1410 64.5 1638 30.5 775 914 203 15.5 394 43.88 UW 2 Speed Models UW 3 Speed Models with P-Control or S-Control UW 3 Speed Models Operation UW Models With UniLinc ControlFor Technical Service Distributor ABC UW Models With M30 Control Cycle Number Cycle Name PHM784N UW Models with S-Control Cycle is complete when display reads donE UW Models with P-Control Pre-Operating InstructionsOperating Instructions UW150 Models SW025 UW Models with A-Control Basic Installation/Operation UW Models with B-Control Basic Installation/Operation Disposal of Unit