Alliance Laundry Systems P232156R9 manual UW Models with P-Control, Pre-Operating Instructions

Page 38

Basic Installation/Operation

UW Models with P-Control

Pre-Operating Instructions

1.Turn on the main power source (circuit breaker or cut-off switch on wall). Models with the rotation sensor will display WE-6 Firmware ID Code “HRWC18” and later (i.e., “HRWC19”) after power up. For models without rotation sensor, proceed to step 1 of Operating Instructions.

2.Display shows size of machine and will flash “TEST?” and “SPEED” for 15 seconds.

3.Push Start keypad during the 15 seconds. Machine will test rotation sensing for 15 seconds.

4.Display will flash “POWER” and “WAIT” one time and will display “NEXT00.”

NOTE: If START keypad is not pushed while display flashes “TEST?” and “SPEED” or if rotation sensing fails, then display flashes “POWER” and “WAIT” before showing “NEXT00” for approximately 2 minutes.

Operating Instructions

1.When display shows “NEXT00,” washer- extractor is ready to be loaded with laundry.

2.On UW35 – UW125 models, use left hand to press and hold the door unlock button located on the lower right front of the control panel. Refer to Figure 21.

UW35 – UW125 MODELS

MD003J

Figure 21

WARNING

Do not operate machine in a cycle with program keymode switch in program position. Program keymode switch must be in run position at all times, except when editing or programming cycle or setup information.

W528

3.On UW35 – UW125 models, use right hand to turn door handle clockwise and swing the door left to open. Refer to Figure 22.

UW35 – UW125 MODELS

MD004J

Figure 22

36

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F232156

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Washer-Extractors Page Contents Explanation of Safety Messages Important Safety InstructionsBasic Installation/Operation Safety Decals Operator Safety Weight And Shipping Information General SpecificationsSpecifications 100 125 150 Overall Dimensions UW UniLinc and M30 Control ModelsCylinder Speeds / Centrifugal Force Data Door Opening InformationDrive Train Information Balance DetectionElectrical Heating Optional Water Consumption Power ConsumptionUW A-Control, Variable-Speed Models MED Uwpv Models Specifications 100 125 150 Overall Dimensions UW P-Control, Variable-Speed ModelsWash/reverse, RPM / g Distribution, RPM / g UW 2 Speed Models UW35 UW60 Overall Dimensions Domestic shipping volume, ft.3 m3Cylinder Speeds/Centrifugal Force Data UW 3 Speed Models UW35 UW60 Overall Dimensions UW 3 Speed Models with P-Control or597 561 100 125 150 Crush hazardUniLinc and M30 Control Models 911 14 UW150TV Uwav Models Models UW 35 Uwpv Pocket Hardmount Machine Dimensions Refer to and Figure Uwpv ModelsUW35PV UW125PV UW150PV 55.5 1410 64.5 1638 30.5 775 914 203 15.5 394 43.88 UW 2 Speed Models UW 3 Speed Models with P-Control or S-Control UW 3 Speed Models Operation UW Models With UniLinc ControlFor Technical Service Distributor ABC UW Models With M30 Control Cycle Number Cycle Name PHM784N UW Models with S-Control Cycle is complete when display reads donE Operating Instructions UW Models with P-ControlPre-Operating Instructions UW150 Models SW025 UW Models with A-Control Basic Installation/Operation UW Models with B-Control Basic Installation/Operation Disposal of Unit
Top Page Image Contents