CONNECTING THE WATER LINES
•IMPORTANT: Use new hoses when installing the washer. Do NOT reuse old hoses.
•IMPORTANT: Use ONLY the inlet hoses provided with this laundry product. Aftermarket hoses are not guaranteed to fit or function correctly. Other hoses may not tighten correctly and could cause leaks. Subsequent damage to product or property will not be covered under the terms of the product warranty.
•Water supply pressure must be between 14.5 PSI and 116 PSI (100~800 kPa). If the water supply pressure is more than 116 PSI, a pressure reducing valve must be installed.
•Periodically check the hose for cracks, leaks, and wear, and replace the hose if necessary.
•Make sure that the water lines are not stretched, pinched, crushed, or kinked.
•The washer should never be installed or stored in a
location subject to freezing temperatures. Damage to the water lines and internal mechanisms of the washer can
result. If the washer was exposed to freezing temperatures prior to installation, allow it to stand at room temperature for several hours before use and check for leaks prior to operation.
f-
Water HoseRubber Seal (to waterinlet
on washer) X
f
For cold water For hot water
Water Inlets
2.Attach the red, hot water line to the hot water inlet on the back of the washer. Attach the blue, cold water line to the
cold water inlet on the back of the washer. Tighten the | ilii li |
| |
fittings securely. |
|
NOTE: Be careful not to |
|
since this will damage the valve and could result in |
|
property damage from leaks. |
|
WaterTap |
|
Rubber Seal | Water Hose |
| (to tap) |
,J
1.Inspect the threaded fitting on each hose and make sure there is a rubber seal in place in both ends.
3.Connect the water supply hoses to the HOT and COLD water faucets tightly by hand and then tighten another 2/3 turn with pliers. Turn ON the water faucets and check for leaks.
9